Ultra electronic Prima 2e Coercivity setting mode Test print, Non-contact IC antenna setting mode

		Operation		(continued)
			Coercivity setting mode						Test print
Set coercivity for writing data on the ISO compatible								Test print is provided for printing a test pattern
magnetic stripe card.								contained in the printer (there is only one pattern).
								Operating the printer independent of the host computer
					EXIT			enables you to find out the source of trouble if there is a
	> M G I S O T y p e
								problem in the system.
				L o - C o		Exit user mode				EXIT
								> T e s t P r i n t
						ENTER			O K ?		Exit user mode
Press				to select the setting and press			to save.
	(The electronic beep sounds.The beep will not sound							ENTER
	if the buzzer mode setting is set to off.)							Press	to carry out test printing.
									(The electronic beep sounds.The beep will not
		Lo-Co
									sound if the buzzer mode setting is set to off.)
		238⋅ 102 [A/m] (300 [Oe])
								P r i n t i n g . .
		Hi-Co
		218⋅ 103 [A/m] (2750 [Oe])

Non-contact IC antenna setting mode

To use non-contact IC cards, set the antenna position at which the cards stop.

> I C A n t e n n a P o s . EXIT

Exit user mode

N o n e

Non-contact IC antenna position:

3 settings

ENTER

Pressto select the setting and press to save.

(The electronic beep sounds.The beep will not sound if the buzzer mode setting is set to off.)

None

No antenna

Ext. Unit

An IC unit antenna is being used

Added on

A compact IC unit is being used.

IC contact setting mode

When using IC cards, specify the contact position to stop the cards.

> I C C o n t a c t P o s .			EXIT
		N o n e		Exit user mode
Set IC contact
position:
3 settings
				ENTER
Press		to select the setting and press			to save.
(The electronic beep sounds.The beep will not sound
if the buzzer mode setting is set to off.)
	None
	No contact
	Ext. Unit
	An IC unit contact is being used
	Built-in
	A built-in contact is being used

A single-sided color pattern is printed. When test printing is completed, the unit will automatically return to ready staus.

				Unit No Setting
	Set Unit No.of the printers to be connected
					EXIT
	> U n i t N o ;
				N o . 1		Exit user mode
	Unit No:
	7 settings
						ENTER
	Press			to select the setting and press			to save.
				(The electronic beep sounds.The beep will not
			EXIT	sound if the buzzer mode setting is set to off.)
After that press				,Then the message is displayed as shown below.
					Turn off the power
		P l e a s e ,
					And then by turning on the power,
		P o w e r o f f			Unit No. setting mode is cancelled.

Transport mode

To set the transport mode.

> T r a n s p o r t m o d e		EXIT
	O K ?		Exit user mode
ENTER	to carry out transport mode.
Press
	(The electronic beep sounds.The beep will not
	sound if the buzzer mode setting is set to off.)
P l e a s e ,		Please turn off the power.
P o w e r o f f		Turnning on the power, then the
		transport mode is canceled.

CAUTION

When shipping or moving the printer, you must set the transport mode. If the printer is not set

the transport mode, it may have a damage.

35