Ultra electronic Prima 2e instruction manual Turning off the power, Is loaded

Operation (continued)

CAUTION

When the printer was occured an

error during printing operation caused by above- mentioned operation or others, the retransfer film was rewinded about 3 panels. If the printer is turned off and on the power or is initialized, the printer occur the printing an error which is “INK RUNOUT” or print results problem because of the printer try to print the used retransfer film. Wind up the retransfer film about 3 panels by unused panel. See p.19 “Caution when loading the retransfer film cassette and/or the ink ribbon cassette” and p.26 “On initialization when the retransfer film casstte and/or the ink ribbon cassette is loaded”.

Turning off the power

1. Check the printer status.

In ready, preheat or error status, check that printer operations are suspended.

2. Turn off the power.

Always wait 10 seconds or more before turning the power back on again.

	About the RESET button
When an error occurs in the printer, press the				RESET
button, then the	ENTER	button.
The printer is initialized with this operation.
If the error still persists, see p.42-43 and take the
appropriate actions.
Then, press the	RESET	button, and the	ENTER	button

again. The printer is initialized, and returns to the “Ready” state.

(When you turn off the power, these procedures are not necessary.)

On Initialization when the retransfer film cassette and/or the ink ribbon cassette

is loaded

Dust or foreign particles may attach on the surface of retransfer film and ink ribbon when their cassette are removed from the printer.

This may cause defective printing such as image void, defective retransfer etc.

To Avoid this, it is recommended that the retransfer film and the ink ribbon are wound up one or two panels after they are reloaded.

Please follow the initialization procedure described below:

1.	Turn the power switch on, and wait until the LCD
	panel displays “Preheat” or “Ready”.
2.		RESET	key.
	Depress the
	LCD panel displays:
		I n i t i a l i z e
				O K ?
3.
	By depressing the			key or the	key, the

LCD panel change accordingly as shown below. Select the wind-up condition, one or two panels. (This set up is not memorized.)

I n i t i a l i z e

2 ' n d P a n e l , O K ?

•Initialized after two panels of the retransfer film and the ink ribbon are would up.

I n i t i a l i z e

N E X T P a n e l , O K ?

•Initialized after one panels of the retransfer film and the ink ribbon are would up.

I n i t i a l i z e

O K ?

•Initialized without winding up. (Default)

4. By depressing the ENTER key, the printer is

initialized according to the selected above set up condition.

26