PRINTER RESET CONDITIONS
The following list describes conditions that are assumed whenever power is applied to the printer, changes have been made in MENU, or a reset escape sequence is received (when the printer is operating in an emulation mode that supports such a sequence).
This list includes all variables that you can modify for all emulations, even though some emulations cannot modify all of the variables shown. Refer to the appropriate section of this manual for the emulation you are using.
Variable |
| Reset Condition |
character pitch |
| according to current form setup |
left margin |
| according to current form setup |
right margin |
| according to current form setup |
line pitch |
| according to current form setup |
form length |
| according to current form setup |
top margin |
| according to current form setup |
bottom margin |
| according to current form setup |
font |
| according to current form setup |
impact mode |
| according to current form setup |
language |
| according to current form setup |
normal/slashed zero |
| according to current form setup |
auto cut mode |
| according to current form setup |
unidirectional mode |
| according to current form setup |
top of form |
| set to current position |
text in an incomplete line |
| discarded |
input buffer |
| cleared (unless reset from host) |
control of data bit 8 |
| accepted as received |
control character symbols |
| according to interface setup |
italics |
| off |
double high |
| off |
double strike |
| off |
double wide |
| off |
emphasized |
| off |
superscript/subscript |
| off |
underline |
| off |
horizontal tabs |
| to every eight columns |
vertical tabs |
| cleared |
7 8