The Speaker Company user manual LCD display Option for TDP-225/324 model

5.3 LCD display (Option for TDP-225/324 model)

This section lists the LCD display messages that you may encounter when operating the printer. Also, it provides solutions.

Messages	Possible Cause	Recovery Procedure
Head Open
	* The printer top cover is open.	* Please close the top cover.
		* Supply a new label roll.
No Paper	* Running out of label.
		* Please refer to the steps in user’s
	* The label is installed incorrectly.
		manual to reinstall the label roll.
	* Gap/black mark sensor is not
		* Calibrate the gap/black mark
	calibrated.
		sensor.
	* Gap/black mark sensor is not
Paper Jam
	set properly.	* Calibrate the gap/black mark
	* Make sure label size is set
		sensor.
	properly.
		* Set label size correctly.
	* Labels may be stuck inside the
	printer mechanism.
Out of Mem
	* The space of FLASH/DRAM or	* Delete unused files in the
	MicroSD card is full.	FLASH/DRAM or MicroSD card.
		* Please take the label away to print
		the next label if peeler module is
		installed.
Take Label
	* Peel function is enabled.	* If peeler module is installed and
		label is been taken away, but the
	Waiting user to take label away
		message remains. Please check if
	to print the next label.
		the peeler module connector is
		connected to main board properly.
		* If peeler module is not installed,
		please disable the peeler function.
	* Cutter jam.	* Remove the jammed label.
Cutter Error
	* There is no cutter installed on	* Make sure the media thickness is
	the printer.	equal or less than 0.19mm.
	* Cutter or cutter driver circuit	* Replace the cutter or cutter driver
	board is damaged.	circuit board.

34