The Speaker Company TDP-225 user manual Using USB interface to setup Ethernet interface

Page 23

3.4 Setting Ethernet by Diagnostic Utility (Option for TDP-225/324

model)

The Diagnostic Utility is enclosed in the CD disk \Utilities directory or can be downloaded from www.tscprinters.com website. Users can use Diagnostic Tool to setup the Ethernet by USB and Ethernet interfaces. The following contents will instruct users how to configure the Ethernet by these interfaces.

3.4.1Using USB interface to setup Ethernet interface

1.Connect the USB cable between the computer and the printer.

2.Turn on the printer power.

3. Start the Diagnostic Utility by double clicking on the

icon.

Note: This utility works with printer firmware V6.00 and later versions.

4.The Diagnostic Utility default interface setting is USB interface. If USB interface is connected with printer, no other settings need to be changed in the interface field.

5.Click on the “Ethernet Setup” button from “Printer Function” group in Printer Configuration tab to setup the IP address, subnet mask and gateway for the on board Ethernet.

17

Image 23

Contents USER’S Manual Contents Skip AUTO.BAS Copyright Declaration Compliances IntroductionProduct Introduction 급기기 Unpacking and Inspection Operations OverviewFront View TDP-225/324 model TDP-225W/324W model Printer OverviewInterior View TDP-225W 324W model TDP-225/324 Model Rear View TDP-225/324 model TDP-225W/324W model Loading the Media SetupSetting Up the Printer TDP-225/324 model TDP-225W324W model TDP-225/324 model TDP-225W/324W modelTDP-225/324 model TDP-225W/324W model Page Rear external label entrance Page Push the peel-off panel back to the printer Close the top cover gently Press the Feed button to test Cutter paper opening Page Diagnostic Tool Function Description Using USB interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page Install MicroSD Memory Card Page Mount the Printer on the Wall Flash Pause the printing job LED and Button FunctionsLED Color Description Feed labelsFunctions 2 Gap/Black Mark Calibration, Self-test and Dump Mode Self-test Gap/black mark sensor intension Printer Initialization  Dump modeSet Gap Sensor as Media Sensor and Calibrate the Gap Sensor Parameter Default setting red/amber 5 blinks  solid green Skip AUTO.BAS LED Status TroubleshootingProblem Possible Cause Recovery Procedure Print ProblemLCD display Option for TDP-225/324 model Printer Part Method Interval MaintenancePage Revise History Date Content Editor