The Speaker Company TDP-225 user manual Using Ethernet interface to setup Ethernet interface

Page 24

3.4.2Using Ethernet interface to setup Ethernet interface

1.Connect the computer and the printer to the LAN.

2.Turn on the printer power.

3. Start the Diagnostic Utility by double clicks on the

icon.

Note: This utility works with printer firmware V6.00 and later versions.

4.Select “Ethernet” as the interface then click on the “Setup” button to setup the IP address, subnet mask and gateway for the on board Ethernet.

5.Click the “Discover Device” button to explore the printers that exist on the network.

6.Select the printer in the left side of listed printers, the correspondent IP address will be shown in the right side “IP address/Printer Name” field.

7.Click “Change IP Address” to configure the IP address obtained by DHCP or static.

The default IP address is obtained by DHCP. To change the setting to static IP address, click “Static IP” radio button then enter the IP address, subnet mask and gateway. Click

18

Image 24

Contents USER’S Manual Contents Skip AUTO.BAS Copyright Declaration Introduction Product IntroductionCompliances 급기기 Operations Overview Unpacking and InspectionPrinter Overview Front View TDP-225/324 model TDP-225W/324W modelInterior View TDP-225W 324W model TDP-225/324 Model Rear View TDP-225/324 model TDP-225W/324W model Setup Setting Up the PrinterLoading the Media TDP-225/324 model TDP-225W/324W model TDP-225/324 model TDP-225W324W modelTDP-225/324 model TDP-225W/324W model Page Rear external label entrance Page Push the peel-off panel back to the printer Close the top cover gently Press the Feed button to test Cutter paper opening Page Diagnostic Tool Function Description Using USB interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page Install MicroSD Memory Card Page Mount the Printer on the Wall Flash LED and Button Functions LED Color DescriptionFeed labels Pause the printing jobFunctions 2 Gap/Black Mark Calibration, Self-test and Dump Mode Self-test Gap/black mark sensor intension  Dump mode Printer InitializationParameter Default setting Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor red/amber 5 blinks  solid green Skip AUTO.BAS Troubleshooting LED StatusPrint Problem Problem Possible Cause Recovery ProcedureLCD display Option for TDP-225/324 model Maintenance Printer Part Method IntervalPage Date Content Editor Revise History