The Speaker Company TDP-225 user manual Setup, Setting Up the Printer, Loading the Media

Page 11

3. Setup

3.1Setting Up the Printer

1.Place the printer on a flat, secure surface.

2.Make sure the power switch is set to “off”.

3.Connect the printer to the computer with the provided USB cable.

4.Plug the power cord into the AC power cord socket at the rear of the printer, and then plug

the power cord into a properly grounded power outlet.

Note: Please switch OFF printer power switch prior to plug in the power cord to printer power jack.

3.2 Loading the Media

3.2.1Loading the Media

1.Open the printer top cover by pulling the tabs located on each side towards the front of the printer, and then lift the top cover to the maximum open angle.

2.The media holder can be used for 1” and 1.5” media core by rotating the upper part of label holder 180 degrees clockwise. (For TDP-225/324 model only)

1”1.5”

5

Image 11

Contents USER’S Manual Contents Skip AUTO.BAS Copyright Declaration Compliances IntroductionProduct Introduction 급기기 Unpacking and Inspection Operations OverviewFront View TDP-225/324 model TDP-225W/324W model Printer OverviewInterior View TDP-225W 324W model TDP-225/324 Model Rear View TDP-225/324 model TDP-225W/324W model Loading the Media SetupSetting Up the Printer TDP-225/324 model TDP-225W324W model TDP-225/324 model TDP-225W/324W modelTDP-225/324 model TDP-225W/324W model Page Rear external label entrance Page Push the peel-off panel back to the printer Close the top cover gently Press the Feed button to test Cutter paper opening Page Diagnostic Tool Function Description Using USB interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page Install MicroSD Memory Card Page Mount the Printer on the Wall Flash Pause the printing job LED and Button FunctionsLED Color Description Feed labelsFunctions 2 Gap/Black Mark Calibration, Self-test and Dump Mode Self-test Gap/black mark sensor intension Printer Initialization  Dump modeSet Gap Sensor as Media Sensor and Calibrate the Gap Sensor Parameter Default setting red/amber 5 blinks  solid green Skip AUTO.BAS LED Status TroubleshootingProblem Possible Cause Recovery Procedure Print ProblemLCD display Option for TDP-225/324 model Printer Part Method Interval MaintenancePage Revise History Date Content Editor