The next tab is the Survey Parameters Tab (figure 2.17). The Survey Parameters tab contains: the survey tolerance, the survey setpoint, the overtemp setpoint, the simulated load in pounds, and the microns.
Figure 2.17 Report Properties Survey Parameters Tab
The next tab is the Controller Tab (figure 2.18a and 2.18b). This tab contains the Controller manufacturer, the controller model, and the instrument type (newer versions only) in the “Temperature Controller Settings” area and this tab also contains the PID Settings: cycle time, dead band, output limit, PB (Gain), rate, and reset.
Figure 2.18a Report Properties Controller Tab (Version 1.101.0.76 & below)
Super Systems Inc. | Page 48 | SDS Data Logger Manual #4565 Rev D |