NOTE: When you first turn on the Keyboard, both the Power Indicator Light and the Bluetooth Status Indicator Light glow for 5 seconds. You cannot connect the Keyboard to your iPad until only the Power Indicator Light glows.
4On your iPad, tap Settings.
5Open Bluetooth and make sure Bluetooth is on.
6On the Keyboard, press the Bluetooth Connection Button. The Bluetooth Status Indicator Light starts blinking for 10 minutes or until connected to a device.
7The Keyboard now appears on your iPad screen. Tap Bluetooth Wireless Keyboard.
8Your iPad screen displays a passkey. Enter the passkey on the Keyboard, and press Enter.
9Your iPad screen shows the Keyboard as Connected. On the Keyboard, the Bluetooth Status Indicator Light turns off.
10You can now use your Keyboard to type in any app.
NOTE: To insure the K Lock key works correctly please ensure you do the following: Home page > Settings > General > Passcode key. Verify “Require Passcode” is set to “Immediately” otherwise a keyboard unlock will not require a passcode. Go back to previous menu and verify “Passcode Lock” is On.
Note the following about the Bluetooth connection between the keyboard and your iPad:
•Keyboard will go into pairing mode if the On/Off Switch is pressed for 5 seconds or longer then released (regardless of on or off state).
•Press the On/Off Switch for 1.5 to 5 seconds then release = toggle keyboard power (on to off, off to on).
•First turn (Factory default, no prior paired BT devices) – enter pairing mode automatically.
•In ON state only - Hold “CTRL + FN + F” for 3 seconds or more = reset to factory default mode (clear all previously paired BT devices in memory), ALL LEDs should flash on and off 3 times and keyboard should turn to off mode.
•If no active key press for 1 minute, the unit should go to sleep mode.
•Anytime a key is pressed in sleep mode, the keyboard should automatically connect to last paired iPad if present. If iPad is not found after waking from sleep mode within 30 seconds, the device should go back to sleep.
4
LED Behavior and Explanation
LED Behavior | Explanation | ||
|
|
|
|
|
|
| • If the KeyStand is off, asleep, or the battery is dead, the LEDs will remain |
|
|
| |
|
|
| off. |
•Initially at
lit for 5 seconds.
• After 5 seconds the Bluetooth LED will turn off, followed by the Power LED 0.5s later.
•When the Bluetooth Connection Button is pressed, the Power LED will
stay solidly lit, while the Bluetooth LED will begin to blink for 10 minutes or until connected to an iPad.
•Blink pattern: ON 1s, OFF 0.5s
•Once the KeyStand is connected with your iPad, the Power LED will
remain lit and all others will go off.
• Also, if the KeyStand is awoken from sleep mode, the Power LED will turn on immediately.
• While the KeyStand is connected to your iPad, the state of the Caps Lock toggle is shown by the Caps Lock LED.
• When the KeyStand is plugged into a power source, the Charge LED will turn red and turn off only when charge is completed.
Charge the Battery
Charge your KeyStand before initial use or when the Charging Indicatorblinks green.
1Insert the small end of the Charging Cable into the micro USB Charging Connector on the Keyboard.
2Insert the other end of the Charging Cable into your iPad charger.
3Plug your iPad charger into a working outlet. The Charging Indicator Light glows red.
4When the Keyboard is fully charged, the Charging Indicator Light turns off.
5