Panasonic KX-FLB756AL Specifications, Technical data about this product, ITU-T No Test Chart

Page 82

Specifications

Technical data about this product!

Applicable lines:

Public Switched Telephone Network

Document size:

Max. 216 mm in width / Max. 600 mm in length

Effective scanning width:

208 mm

 

Effective printing width:

A4:

202 mm

 

Letter/Legal:

208 mm

Transmission time*:

Approx. 4 s/page (ECM-MMR Memory transmission)**

Scanning density:

Horizontal: 11.8 pels/mm

 

Vertical: 3.9 lines/mm – in standard resolution

 

11.8 lines/mm – in fine/super fine/photo resolution

Halftone level:

64-level

 

Scanner type:

Contact Image Sensor (CIS)

Printer type:

Laser Printer

 

Data compression system:

Modified Huffman (MH), Modified READ (MR),

 

Modified Modified READ (MMR)

Modem speed:

33,600 / 31,200 / 28,800 / 26,400 / 24,000 / 21,600 / 19,200 / 16,800 /

 

14,400 / 12,000 / 9,600 / 7,200 / 4,800 / 2,400 bps; Automatic Fallback

Operating environment:

10 °C – 32.5 °C, 20% – 80% RH (Relative Humidity)

Dimensions (H x W x D):

217 mm x 443 mm x 461 mm

Mass (Weight):

Approx. 9.2 kg

 

Power consumption:

Standby:

Approx. 7 W

 

Transmission:

Approx. 17 W

 

Reception:

Approx. 250 W

 

Copy:

Approx. 250 W

 

Maximum:

Approx. 900 W (When the fuser unit turns on)

Power supply:

220 – 240 V AC, 50/60 Hz

Memory capacity:

Approx. 150 pages of memory transmission/reception

 

(Based on the ITU-T No. 1 Test Chart in standard resolution.)

Laser diode properties:

Laser output:

Max. 5 mW

 

Wave length:

760 nm – 800 nm

 

Emission duration: Continuous

Print speed:

Approx. 10 ppm (pages per minute)

Printing resolution:

600 x 600 dpi

 

** Transmission speed depends upon the contents of the pages,

ITU-T No. 1 Test Chart

resolution, telephone line conditions and capability of the other party’s

 

 

machine.

 

** Transmission speed is based upon the ITU-T No. 1 Test Chart. If the

 

capability of the other party’s machine is inferior to your unit, the

 

transmission time may be longer.

 

Note:

Any details given in these instructions are subject to change without notice.

The pictures and illustrations in these instructions may vary slightly from the actual product.

82

Image 82
Contents Model No. KX-FLB756AL Trademarks For your future referenceCopyright For Australian users Service difficulties InstallationImportant information for Australian users Safety instructions Important safety instructionsOther Information Toner cartridge Laser radiationFuser unit Drum unitFor Best Performance Accessory information AccessoriesIncluded accessories Model No Usage SpecificationsTable of Contents Fax sending/receiving using Multi-Function Station software Using the fax machine as a printerUsing the fax machine as a scanner Advanced featuresHelp function Help ButtonHelp SET Front view Finding the ControlsOverview Rear viewLocation Unlocking the shipping lock SetupConnecting the document cover Label for unlockingToner cartridge and drum unit SurfaceTurn the two levers on the toner Toner save featureCartridge with firm pressure Paper stacker Paper stacker and paper trayPaper tray Recording paper Adding paperLonger, uncoiled end Telephone Handset cord line cord ConnectionsConnect the handset cord To use the fax machine with a computer on the same lineDate and time, your logo and fax number Setting the date and timeMenu SET Handset Mute Setting your logoRecall SET To select characters with the dial keypad To select characters using +orDisplay order of characters To delete a number Setting your facsimile telephone numberMenu Recall SET Ringer volume VolumeAdjusting volume Handset receiver volumeStoring names and telephone numbers into one-touch dial Automatic DiallingLower SET Stop Registered NAME= Storepress SET Erasing a stored entry Editing a stored entrySET Stop Using the directory Using one-touch dialTo search for a name by initial Caller ID Caller ID service from your phone companyTo confirm caller information using the Caller ID list How Caller ID is displayedTo display the caller’s telephone number Viewing and calling back using caller informationStop FAX Start Caller ID Display while viewingDisplay Press w To cancel erasing, press , then p Press wErasing caller information Stop SETStation keys For navigator directory Press orLower SET Sending Faxes Using the auto document feederMonitor REDIAL/PAUSE Scan Resolution FAX Start Sending a fax manuallyTo stop transmission Using the scanner glassScan Resolution Stop FAX Start Sending report for confirmationWhen the paper size is set to Letter When the paper size is set to A4Documents you can send Sending a fax using one-touch dial and navigator directory Lower Resolution Scan FAX Start StopManual Broad Broadcast transmissionProgramming entries into the broadcast memory Broadcast Manual Broad Menu Lower SETAdding a new entry into the broadcast memory Display Press +or -until the following is DisplayedTo cancel erasing, press Press w Erasing a stored entry in the broadcast memoryTo cancel the broadcast setting Manual Broad Stop Scan Resolution FAX Start SETTo send the same document using the scanner glass Sending the same document to pre-programmed partiesWhen receiving faxes Setting the unit to receive faxesWhen receiving calls When receiving phone Receiving FaxesTurn Auto Answer off by pressing PQ When receiving callsRemote fax activation Activating TEL mode TEL mode Answering all calls manuallyReceiving a fax manually Activating FAX only mode FAX only mode All calls are received as faxesIf the FAX on light is off, turn it on by pressing Display Set the fax machine to the desired receiving mode p Using the unit with an answering machineSetting up the fax machine and an answering machine Activate the answering machineAnswering machine will record voice messages automatically How the fax machine and answering machine workReceiving phone calls Receiving faxesReceiving Faxes / Distinctive Ring Using with the ring detection featureExtension telephone Copying Stop Copy Start ResolutionStop Resolution Copy Start Making a copyTo enlarge a document Using the auto document feederUsing the scanner glass To reduce a documentSetup PC Connecting to a computerConnect the fax machine to the PC Installing Multi-Function Station softwareTo uninstall the software Important notice for USB cable usersActivating Multi-Function Station software Printing PC Using the fax machine as a printerSetting the printer properties Printing from Windows applicationsTransparencies LabelsEnvelopes Using other applications Using the fax machine as a scannerUsing Multi-Function Viewer Scanning PCRemote Control PC Operating the fax machine from your computerFax sending/receiving using Multi-Function Station software PC FaxIf the fax machine’s memory stores a received fax document Receiving a fax into your PCViewing a received document You can load the document into your PCProgramming Features SummaryGeneral programming method Error Basic featuresHow to set the basic features Programming tableTone OFFParallel Advanced features How to set the advanced featuresNormal Australia Error Messages ReportsDisplay message Cause & solution DisplayService personnel You cannot change the cable type setting feature #15 onWhen making a copy, the document being stored exceeds Install paper pGeneral When a function does not work, check hereOperations Fax sendingFax receiving Receiving modeCopying Using an answering machine Multi-Function StationRemove the document and reinsert it If a power failure occursEven after clicking Cancel, scanning continues Multi-Function Station does not work properlyReplacing the toner cartridge and the drum unit ReplacementNew toner cartridge, shake it vertically Green drum surface Toner cartridge to snap into positionRecording paper jam Replacement / JamsWhen the recording paper has jammed in the unit Waste disposal methodWhen the recording paper is not fed into the unit properly JamsWhite plate and glasses Jams / CleaningDocument jams sending White plate and scanner glassCleaning Lower glassDocument feeder rollers Press or until the desired item is Printed ReportsReference lists and reports Press wto start printingTechnical data about this product SpecificationsITU-T No Test Chart Paper specifications Index Code/Feature nameProgram index Index Index Page 62, 4-chome, Minoshima, Hakata-ku, Fukuoka 812-8531, Japan PFQX1948ZA KM0703DH0