American Power Conversion 2200 manual Service

Page 22

Problem

Possible Cause

Solution

 

 

 

Low battery light is

The unit is shut down and the

None. The unit will return to normal

on and the on-line

battery is discharged from an

operation when the power is restored and

light is off.

extended power outage.

the battery has a sufficient charge.

 

 

 

 

 

Allow the batteries to recharge for at least

The replace battery

Weak batteries.

four hours. If the problem persists after

recharging, replace the batteries. See

 

light is lit.

 

 

section 10.

 

 

 

 

 

 

Replacement batteries not

Confirm the battery connections. See

 

connected properly.

section 10.

 

 

 

9. Service

If the unit requires service:

1.Use the troubleshooting section (section 8) to eliminate obvious causes.

2.Verify that no circuit breakers are tripped. A tripped circuit breaker is the most common unit problem! See section 6.2.

3.Go to section 5.3 and perform a self-test to check the battery.

4.See the front of this manual for the correct telephone number. Call customer service for a return material authorization number (RMA#). If customer service is not available in your area, call the dealer that sold the unit.

Note the model number of the unit, the serial number, and the date purchased. A techni- cian will ask you to describe the problem and help solve it over the phone, if possible, or will give you an RMA#.

If the unit is under warranty, repairs are free. If not, there will be a charge for repair.

5.Pack the unit in its original packaging. If the original packing is not available, ask customer ser- vice about obtaining a new set.

It is important to pack the unit properly to avoid damage in transit. Never use styrofoam beads for packaging. Damage sustained in transit is not covered under warranty.

Include a letter with your name, RMA#, address, copy of the sales receipt, description of the trouble, your daytime phone number, and a check (if necessary).

6.Mark the RMA# on the outside of the package. The factory cannot accept any package without this marking.

7.Return the unit by insured, prepaid carrier to the address at the front of this manual.

18

Image 22
Contents Smartups Part Number 990-7042A Revision Revised 7/97 Contents/Índice Page Thank you IntroductionIntroduction Please save the packaging materialsVA 1400 VA Radio Frequency InterferenceVA and 3000 VA Computer Interface and Accessory Slot FeaturesIntelligent Battery Management Theory of OperationSafety Presentation Front panelRear Panel 3000 VA 1400 VA700 VA Inspection InstallationPlacement Protection StrategiesCharge the Battery Install Accessory OptionalConnect to Utility Connect Ground Leads to Tvss Connector Optional Check the Site Wiring Fault IndicatorConnect the Loads Operation Switch OnSwitch Off Self-testLoad Bar Graph Battery Charge Bar GraphUtility Voltage Bar Graph SmartBoost and SmartTrim Cold StartLow Battery Warning Interval Voltage SensitivityAlarms Options Troubleshooting Service Replacing the Battery Replacement BatteriesBattery Replacement Procedure 450 through 1400 VA models Battery Replacement Procedure 2200 and 3000 VA models Storage conditions StorageExtended storage Specifications EnglishHow to Determine On-battery Run Time Typical On-Battery Run Time Versus Load, in Minutes Model User Configuration Items Importante IntroduçãoObrigado Guarde a embalagemInterferência de Radiofreqüência VA e 3000 VARecursos Método de OperaçãoGerenciamento Inteligente de Baterias Segurança Interface do Computador e Slot de AcessóriosApresentação Painel frontal2200 e 3000 VA Painel Traseiro1000 e 1400 VA 450 e 700 VA Localização InstalaçãoInspeção Estratégias de ProteçãoConexão à Energia Externa Instalação de Acessórios OpcionalCarregue a Bateria Verifique o Indicador de Falha da Fiação Local Conecte as CargasConecte a Fiação de Aterramento ao Conector Tvss Opcional Desligar OperaçãoLigar AutotesteIndicadores de Carga Indicadores de Voltagem Externa Indicadores de Carga da BateriaSmartBoost e SmartTrim Inicialização Fria Sensibilidade da VoltagemIntervalo do Aviso de Bateria Fraca Modo de DesligamentoSobrecarga AlarmesCom Bateria Bateria FracaKits de Interface OpçõesVisão Geral Slot de AcessóriosResolução de Problemas Assistência Técnica Substituição da Bateria AvisoSubstituição das Baterias Page Condições de Armazenamento Armazenamento11.2 Períodos Longos de Armazenamento Especificações Ajustável via software opcionalComo Determinar o Tempo de Autonomia da Bateria Page Itens Configuráveis pelo Usuário Limited Warranty Page Technical Support Numbers