American Power Conversion 2200 manual Replacing the Battery, Replacement Batteries

Page 23

10. Replacing the Battery

This unit has a replaceable battery. Please read section 10.1 before performing the procedure in sec- tions 10.3 or 10.4.

10.1Warning

This Uninterruptible Power Source contains potentially hazardous voltages. Do not attempt to disassemble the unit beyond the battery replacement procedures below. Except for the battery, the unit contains no user serviceable parts. Repairs are performed only by factory trained ser- vice personnel.

The batteries in this unit are recyclable. Dispose of the batteries properly. The batteries contain lead and pose a hazard to the environment and human health if not disposed of properly. Refer to local codes for proper disposal requirements or return the battery to a factory authorized service center. See the instructions with the new battery for more information.

CAUTION—Do not dispose of batteries in a fire. The batteries may explode.

CAUTION—Do not open or mutilate batteries. They contain an electrolyte which is toxic and harmful to the skin and eyes.

CAUTION—To avoid personal injury due to energy hazard, remove wrist watches and jewelry such as rings when replacing the batteries. Use tools with insulated handles. CAUTION—Replace batteries with the same number and type of batteries as originally installed in the unit.

10.2 Replacement Batteries

See your dealer or call the number at the front of this manual for information on replacement bat- tery kits and battery recycling.

English

19

Image 23
Contents Smartups Part Number 990-7042A Revision Revised 7/97 Contents/Índice Page Please save the packaging materials IntroductionIntroduction Thank youVA and 3000 VA Radio Frequency InterferenceVA 1400 VA Theory of Operation FeaturesIntelligent Battery Management Computer Interface and Accessory SlotSafety Front panel Presentation3000 VA 1400 VA Rear Panel700 VA Protection Strategies InstallationPlacement InspectionConnect to Utility Install Accessory OptionalCharge the Battery Connect the Loads Check the Site Wiring Fault IndicatorConnect Ground Leads to Tvss Connector Optional Self-test Switch OnSwitch Off OperationUtility Voltage Bar Graph Battery Charge Bar GraphLoad Bar Graph Cold Start SmartBoost and SmartTrimVoltage Sensitivity Low Battery Warning IntervalAlarms Options Troubleshooting Service Replacement Batteries Replacing the BatteryBattery Replacement Procedure 450 through 1400 VA models Battery Replacement Procedure 2200 and 3000 VA models Extended storage StorageStorage conditions English SpecificationsHow to Determine On-battery Run Time Typical On-Battery Run Time Versus Load, in Minutes Model User Configuration Items Guarde a embalagem IntroduçãoObrigado ImportanteVA e 3000 VA Interferência de RadiofreqüênciaGerenciamento Inteligente de Baterias Método de OperaçãoRecursos Interface do Computador e Slot de Acessórios SegurançaPainel frontal Apresentação1000 e 1400 VA Painel Traseiro2200 e 3000 VA 450 e 700 VA Estratégias de Proteção InstalaçãoInspeção LocalizaçãoCarregue a Bateria Instalação de Acessórios OpcionalConexão à Energia Externa Conecte a Fiação de Aterramento ao Conector Tvss Opcional Conecte as CargasVerifique o Indicador de Falha da Fiação Local Autoteste OperaçãoLigar DesligarIndicadores de Carga SmartBoost e SmartTrim Indicadores de Carga da BateriaIndicadores de Voltagem Externa Sensibilidade da Voltagem Inicialização FriaModo de Desligamento Intervalo do Aviso de Bateria FracaBateria Fraca AlarmesCom Bateria SobrecargaSlot de Acessórios OpçõesVisão Geral Kits de InterfaceResolução de Problemas Assistência Técnica Aviso Substituição da BateriaSubstituição das Baterias Page 11.2 Períodos Longos de Armazenamento ArmazenamentoCondições de Armazenamento Ajustável via software opcional EspecificaçõesComo Determinar o Tempo de Autonomia da Bateria Page Itens Configuráveis pelo Usuário Limited Warranty Page Technical Support Numbers