American Power Conversion 60kW InfraStruXureTM System manual Connect the Power Source to the PDU

Page 22

Connect the Power Source to the PDU

Access the PDU Main Input switch

Open the back doors of the PDU, unlock the top, smaller door, using the provided red key, and loosen the two screws holding the larger, hinged door in place.

Attach conduit to the PDU for the input conductors

1.Remove the rectangular gland plate by loosening the captive screws, using a Phillips or standard screwdriver:

– In the bottom of the PDU for wiring under a raised floor

14	InfraStruXure System—Installation and Start-Up

Image 22

Contents Installation and Start-Up Page About this Manual Page Contents Start-Up Procedure Appendix a Operation Page Cross-reference symbols used in this manual Safety symbols used in this manualOverview Installation/Maintenance Receiving/movingTotal Power Off Emergency Power Off EPOPage InfraStruXure PDU DimensionsNetShelter VX Enclosure Space Considerations Weight Considerations Component Maximum WeightHeat Output Electrical requirements Electrical Requirements and SpecificationsProcedures requiring a licensed electrician 208V Input 480V Input 600V InputEmergency Power Off EPO Overview Basic Installation Procedure Licensed electrician must connect the power sourceSite Planning Basic Installation Procedure Installation Procedures Level the PDU and NetShelter EnclosuresAccess the PDU Main Input switch Connect the Power Source to the PDUAttach conduit to the PDU for the input conductors Installation Procedures Connect the Power Source to the PDU Torque specs and tools required Install a circuit breakerTerminal Torque Tools Connect input conductors 208V input without a transformerConnect an Emergency Power Off Switch Contact closure 24VAC 24VDC Contact closure is recommendedContact Closure-Normally Closed Contact Closure-Normally Open24VAC/VDC-Normally Open Problem Action Safety warnings Overview How to connect contacts to the PDU Monitoring Unit Relay output specifications990-1393B Cable Ladders for overhead wiring across rows Install the Rack Power Distribution Units PDU Install InfraStruXure Rack-Mount DevicesInstall the Rack Automatic Transfer Switches ATS Install the InfraStruXure Manager and Hub or SwitchRoute and Attach Overhead Wiring Route and attach power cables to equipment racksInstallation Procedures Route and Attach Overhead Wiring Installation Procedures Route and Attach Overhead Wiring Wiring Under the Floor Installation Procedures Wiring Under the Floor Route Data Cables to the InfraStruXure Manager Hub or Switch Start-Up Procedure Ensure that all power is offApply power to the system Start-Up Procedure InfraStruXure System Configure the InfraStruXure Manager How to Apply Power to the System Appendix a OperationDistribution panel circuit breakers How to Ensure Total Power Off For PDU with transformer Set the MainPage General changes Changes by page numberPage Index InfraStruXure System-Installation and Start-Up Page Page Page Page Page Page Page 990-1638B