Epson RC170 manual Installing Operator Panel

Page 19

3. Installation

-The Operator Panel is designed for vertical installation. It can also be installed at an angle. However, in this case, limit the angle of tilt from the vertical within 30 deg.

Within 30deg.

-If the Operator Panel is installed at an angle of tilt exceeding 30 deg, take measures, such as forced air cooling, to prevent the operating ambient temperature from exceeding 40 degC.

-Do not install the Operator Panel horizontally.

3.2.3Installing Operator Panel

(1)Set the Operator Panel into the panel cutout from the front.

(2)Insert the hook of the mounting metal hasps into the four mounting holes at the top and bottom of the Operator Panel.

Mounting Holes

(3)Slide the mounting metal hasps towards the rear.

OP1 Rev.1a

11

Image 19

Contents OP1 RC170 Option Operator Panel OP1 Rev.1a RC170 Option Operator Panel OP1Foreword Trademarks Manufacturer & Supplier Before Reading This ManualTable of Contents Programming for Operator Panel Conventions SafetySafety Precautions SafetyPage Emergency Stop How to Reset an Emergency Stop StatePendant to the Controller Environmental Specifications SpecificationsSpecification Tables Electrical SpecificationsTouch Panel Function switchesEmergency Stop switch Part Names and FunctionsTool connector Specifications Power LampTeach Pendant connector Bypass Plug Hcom connectorAppearance without mounting metal hasps Appearance and DimensionsExternal appearance with mounting metal hasps Mounting Metal Hasps Dimensions Panel Cutout DimensionsGasket InstallationInstallation UnpackingMounting Holes Installing Operator Panel Connecting Cables Teach Pendant Connection Basic Operations OperationOperation Operator Panel screen image Startup ScreenStartup screen Program Execution Screen Program number Operation Serious Error stateError state How to set the Operator Panel to a control devicePause program Cancel programReset Execute programTask Monitor Screen Monitor screen 32-bit display OP1 Rev.1a I/O Monitor ScreenOperation Monitor screen 8-bit display System History Screen Application Screen Application screen text string input Application screen numerical value inputStartup screen Setup screen Language Setup ScreenOperation Change display after program execution Programming for Operator Panel Programming for Operator PanelDisplay on Operator Panel Simple Display ProgramData Input from Operator Panel Executing the display device selection commandDisplay Device Value Input String Input About Display Language Contrast Adjustment Maintenance and InspectionMaintenance and Inspection Brightness Adjustment Case and Display Cleaning Firmware UpdateApproximately 3.0 mm from the groove OP1 Rev.1a Replacement ProcedureAbout Gasket Gasket evenly sticking outBacklight Replacement Regular Maintenance InspectionMaintenance Parts List