Epson RC170 manual About Gasket, Replacement Procedure, Gasket evenly sticking out

Page 43

6. Maintenance and Inspection

6.5 About Gasket

NOTE

)

The gasket is used for dust-proof and dip-proof performance.

-Gasket that is used for long periods of time or once has been installed on the panel is scratched or dirty, and may not qualify IP65 dust-proofing and drop-proofing performance. Replace the gasket periodically* for stable dust-proof and dip-proof performance.

*Periodically: Yearly, or when obvious scratches or dirt is seen.

-The drip-proof performance (IP65 equivalent) is assured only when the gasket is mounted properly to the groove.

Replacement Procedure

(1)Put the Operator Panel on a horizontal place with the display side down.

(2)Remove the gasket.

Gasket

(3) Insert new gasket.

NOTE

)

-Do not insert the seams of the gasket at the corners of the Operator Panel.

-Attach the gasket so that its seams come to the bottom side the Operator Panel.

Seams

(4)Make sure to check the mounting condition of the gasket.

(The gasket evenly sticking out		3.0mm
approximately 3.0 mm from the groove)

OP1 Rev.1a

35

Image 43

Contents OP1 RC170 Option Operator Panel OP1 Rev.1a RC170 Option Operator Panel OP1Foreword Trademarks Manufacturer & Supplier Before Reading This ManualTable of Contents Programming for Operator Panel Conventions SafetySafety Precautions SafetyPage Emergency Stop How to Reset an Emergency Stop StatePendant to the Controller Environmental Specifications SpecificationsSpecification Tables Electrical SpecificationsTouch Panel Function switchesEmergency Stop switch Part Names and FunctionsTool connector Specifications Power LampTeach Pendant connector Bypass Plug Hcom connectorAppearance without mounting metal hasps Appearance and DimensionsExternal appearance with mounting metal hasps Mounting Metal Hasps Dimensions Panel Cutout DimensionsGasket InstallationInstallation UnpackingMounting Holes Installing Operator Panel Connecting Cables Teach Pendant Connection Basic Operations OperationOperation Operator Panel screen image Startup ScreenStartup screen Program Execution Screen Program number Operation Serious Error stateError state How to set the Operator Panel to a control devicePause program Cancel programReset Execute programTask Monitor Screen Monitor screen 32-bit display OP1 Rev.1a I/O Monitor ScreenOperation Monitor screen 8-bit display System History Screen Application Screen Application screen text string input Application screen numerical value inputStartup screen Setup screen Language Setup ScreenOperation Change display after program execution Programming for Operator Panel Programming for Operator PanelDisplay on Operator Panel Simple Display ProgramData Input from Operator Panel Executing the display device selection commandDisplay Device Value Input String Input About Display Language Contrast Adjustment Maintenance and InspectionMaintenance and Inspection Brightness Adjustment Case and Display Cleaning Firmware UpdateApproximately 3.0 mm from the groove OP1 Rev.1a Replacement ProcedureAbout Gasket Gasket evenly sticking outBacklight Replacement Regular Maintenance InspectionMaintenance Parts List