Toshiba RKP004Z instruction manual Remote control optional, Inverter unit, Remote keypad

Page 13

2. Installing the LCD remote keypad

2.2 Remote control (optional)

Connecting the remote keypad to the inverter unit with a dedicated interconnect cable and a connector (optional) makes it possible to operate the inverter from a distant point up to 5m from it.

Warning

Prohibited

●Never connect the unit to any inverter other than a VF-AS1/PS1 series inverter or any communication device. Do not use any cable other than an optional interconnect cable designed specifically for the unit.

If the correct cable was not used, this might cause the unit to break down and result in an electric shook or fire.

Turn off the inverter, as shown in the figure below.

<Inverter unit>

*Leave a space of 60mm or more for the interconnect cable.

Connector (optional)

< Remote keypad >

Dedicated interconnect cable (optional) *

Serial RS485 connector (2-wire)

*The pin configuration of the dedicated interconnect cable is different from that of any other commercially available cable.

Therefore, be sure to use the dedicated interconnect cable.

2-3

Image 13

Contents LCD Remote Keypad „ Explanation of model code Introduction„ Check product purchase Model number Introduction „ Optional products„ Limitation of use Safetyprecautionsprecautions Explanation of markings„ Transportation and installation Safety precautions „ Handling in general„ Disposal Safety precautions „ Operations„ Notes on operations Contents Names. Namesand functionsand functions „ LCD panel Names and functionsNames and functions „ About the change of parameter settings Installing the remote keypad to the inverter Installing the LCD remote keypad Installing the remote keypad to the board optionalInverter unit Remote control optionalRemote keypad インバータ⇒パネル Language Selection window appears on the screenParameter Setup Mode Top View ModeStatus Monitor Mode 54. .標About準モニタモードavailable modesSetting a panel operation frequency Operation. in Top View Modein Top View Mode„ Explanation of the top window Functions of function keys„ To change the frequency during operation Using an Easy key functionAlways Quick mode parameter PSEL=2 Operation in Top View ModeOperation Panel and Remote When used with a VF-AS1 inverter Operation Panel and Remote When used with a VF-PS1 inverterSelecting a language to be displayed Operation in Top View Mode Peak/Minimum Hold settingPress the F2 Lng key Select/confirm the desired language with the control dialPress the F4 key to carry out jog run Performing jog run60.0 Hz Emergency stop/reset operation„ When Quick mode is selected Operation. in Parameter inSetupParameterModeSetup ModeSelect/confirm History function using the control dial „ In this window, settings can be changedOperation in Parameter Setup Mode Setting a basic parameterSelect/confirm Basic parameters using the control dial Select/confirm Extended parameters using the control dial Setting an extended parameterChange the parameter setting ［CMOd］ Select/confirm Changed Parameters using the control dialItems displayed Description Display Operation. in Status Monintor modeStatus Monitor ModeDisplaying details of an item monitored VFAS1 VFPS1 Operation. Operationby copy functionin a copy functionOperation by a copy function Copy to LCDDisplay of copy loading（fixed screen） Display of copy finish［Copy to the inverter］ Copy to inverterConfirm a memory information Function Key Display Position WarrantyList of function key functionsFunction Reference Specifications 710. 状態. モSpecificationsニタモードでの操作„ Outside dimensions unit mm Problems Possible causes Remedies Before. Beforemaking a servicemakingcall a service callBefore making a service call Warranty. Warranty