INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
(Revision Date: Jan. 19, 2006)
2. Strip Module
•System Mode Settings for Stripping PET Labels
When using PET labels on the strip module, please set the following system mode parameters in advance.
1.Connect the printer to a PC.
2.Load a PET label stock on the printer.
3.Turn ON the printer while holding down the [FEED] key and [PAUSE] key.
4.When “<1>DIAG. “ is displayed on the LCD, press the [FEED] key to choose <2>PARAMETER SET” menu.
5.Press the [PAUSE] key repeatedly until “PRE PEEL OFF” appears on the LCD.
6.As the default is OFF, choose “PRE PEEL OFF ON” with the [FEED] or [RESTART] key. Then, press the [PAUSE] key.
Turn the power ON.
FEED
<1>DIAG.
V1.1
FEED
<2>PARAMETER SET
PAUSE
PAUSE
7.“P.P. FEED +0.0mm” is displayed on the LCD.
Press the [PAUSE] key repeatedly until “PEEL OFF TRQ” appears on the LCD.
<2>PARAMETER SET PRE PEEL OFF OFF
FEED
RESTART
8.This menu is to set the strip motor torque. As the default is R0, choose R3 with the [FEED] or [RESTART] key. Then, press the [PAUSE] key.
NOTE: Setting the motor torque higher makes the strip issue easier.
Strip motor | Value | |
torque | ||
| ||
Low | R0 | |
| R1 | |
High | R2 | |
R3 |
<2>PARAMETER SET
PRE PEEL OFF | ON | |||
|
|
|
|
|
|
|
|
|
|
|
| PAUSE |
| |
|
|
|
|
|
|
|
|
|
|
<2>PARAMETER SET |
| |||
P.P.FEED | +0.0mm |
| ||
|
|
|
|
|
|
|
| ||
|
| PAUSE |
| |
|
|
|
|
|
|
|
|
|
|
<2>PARAMETER SET |
| |||
PEEL OFF TRQ | R0 |
| ||
|
|
|
|
|
|
|
|
| |
|
| FEED |
|
|
|
|
|
|
|
| ||||
<2>PARAMETER SET | ||||
PEEL OFF TRQ | R3 | |||
RESTART
PAUSE
<2>PARAMETER SET
(Continued.)
2- 5