Dell 1100, Dimension B 110 manual Installing Memory

NOTICE: If you remove your original memory modules from the computer during a memory upgrade, keep them separate from any new modules that you may have, even if you purchased the new modules from Dell. You should install your new memory modules in connectors DIMM3 and DIMM4. If possible, do not pair an original memory module with a new memory module. Otherwise, your computer may not function at optimal performance.

NOTE: Memory purchased from Dell is covered under your computer warranty.

Installing Memory

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

1Shut down the computer through the Start menu (see page 47).

2Ensure that your computer and attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut down your computer, turn them off now.

NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.

3Disconnect any telephone or telecommunication lines from the computer.

4Disconnect your computer and all attached devices from their electrical outlets, and then press the power button to ground the system board.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.

5Remove the computer cover (see page 52).

6Lay the computer on its side so that the system board is on the bottom of the inside of the computer.

7If necessary, remove a memory module:

a Press out the securing clip at each end of the memory module connector.

bGrasp the module and pull up.

If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.

56

Removing and Installing Parts