Dell 1100, Dimension B 110 manual Battery

8Reattach the front panel (see page 64).

9Replace the computer cover (see page 77).

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

10Connect your computer and devices to electrical outlets, and then turn them on.

11See the documentation that came with the drive for instructions on installing any software required for drive operation.

Battery

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. You can do so by touching an unpainted metal surface on the computer chassis.

A coin-cell battery maintains computer configuration, date, and time information. The battery can last several years.

If you have to repeatedly reset time and date information after turning on the computer, replace the battery.

CAUTION: A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer’s instructions.

To replace the battery:

1Record all the screens in system setup (see page 83) so that you can restore the correct settings in step 8.

2Follow the procedures in "Before You Begin" on page 47.

3Locate the battery socket (see "System Board Components" on page 54).

NOTICE: If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with the object. Ensure that the object is inserted between the battery and the socket before you attempt to pry out the battery. Otherwise, you may damage the system board by prying off the socket or by breaking circuit traces on the system board.

4Remove the battery by carefully prying it out of its socket with your fingers or with a blunt, nonconducting object such as a plastic screwdriver.

5Insert the new battery into the socket with the side labeled "+" facing up, and snap the battery into place.

76

Removing and Installing Parts