NETGEAR JNR1010V2 user manual Connection Status,  To view the connection status, Dhcp connection

JNR1010v2 N150 Wireless Router

• Poll Interval. The interval at which the statistics are updated on this screen.

4.To change the polling frequency, enter a time in seconds in the Poll Interval field, and click the Set Interval button.

5.To stop the polling entirely, click the Stop button.

Connection Status

The content of this screen depends on the type of connection. For example, different information is shown for a PPPoE connection than for a DHCP connection.

To view the connection status:

1.Log in to the router.

For more information, see Log In to Your Router After Installation on page 18.

2.Click the ADVANCED tab.

The Router Status screen displays.

3.In the Internet Port pane, click the Connection Status button.

The Connection Status pop-up screen displays. The following figure shows the connection status information for a DHCP connection.

The content of the Connection Status pop-up screen depends on the type of connection. You can start new connections and end existing connections from this screen.

The following list describes the different types of connections and the associated settings that display on the Connection Status pop-up screen:

•DHCP connection:

The following information displays for a DHCP connection:

-IP Address. The IP address that is assigned to the router.

-Subnet Mask. The subnet mask that is assigned to the router.

Monitoring

75