NETGEAR JNR1010V2 user manual Factory Settings, JNR1010v2 router factory default settings

JNR1010v2 N150 Wireless Router

Factory Settings

You can return the router to its factory settings. Use the end of a paper clip or some other similar object to press and hold the WPS/Reset button on the back panel of the router for at least four seconds. The router resets, and returns to the factory settings that are shown in the following table.

Table 4. JNR1010v2 router factory default settings

Feature		Default Behavior
Router login	User login URL	www.routerlogin.com or www.routerlogin.net
	User name (case-sensitive)	admin
	Login password (case-sensitive)	password
Internet	WAN MAC address	Use default hardware address
connection
	WAN MTU size	1500
	Port speed	AutoSensing
Local area	LAN IP	192.168.1.1
network (LAN)
	Subnet mask	255.255.255.0
	DHCP server	Enabled
	DHCP range	192.168.1.2 to 192.168.1.254
	Time zone	United States is Pacific Time; otherwise, varies by region
	Time zone adjusted for daylight	Disabled
	saving time
Wireless	Wireless communication	Enabled
	SSID name	Preset. For information, see the router label. (For a
	Network key (password)	description of the router label, see Label on page 11.)
	Broadcast SSID	Enabled
	Transmission speed	Auto
		Note: Maximum wireless signal rate derived from IEEE
		Standard 802.11 specifications. Actual throughput varies.
		Network conditions and environmental factors, including
		volume of network traffic, building materials and
		construction, and network overhead lower actual data
		throughput rate.
	Country/region	United States in the US; otherwise, varies by region
	RF channel	Auto
	Operating mode	Up to 150 Mbps

Supplemental Information

90