Canon FAX-L400 manual Sending Methods, Memory Sending, Press FAX to set to Fax mode, Using the ADF

Sending Methods

Memory Sending

The machine begins calling the other party and transmitting the information after all documents are scanned into the memory.

Since the machine is multitasking, you can perform other operations while the machine is sending a fax.

The machine has enough memory to store up to approximately 256 pages* (fewer if the document contains many graphics or particularly dense text).

* Based on Canon FAX Standard Chart No. 1, standard mode.

	• When a large amount of memory is used, MEMORY FULL may be displayed depending on the
NOTE	documents to be sent, and the machine can neither store the scanned documents in memory nor send
	them. In this case, print or delete any documents in memory, or select a lower fax resolution such as
	STANDARD, then send the documents.

■Using the ADF

1Press FAX to set to Fax mode.

Ex:

03/12 2002 TUE 15:11

FaxOnly STANDARD

2Prepare the document and load it face up in the ADF. (→ User’s Guide)

DOCUMENT READY

(Standby to scan)

•To adjust the resolution → pp. 4-1, 4-2.

•To adjust the scanning density → p. 10-4.

3Dial the other party’s fax number.

TEL= 9057951111

Ex:

•For dialling methods → p. 4-3.

•If you enter the wrong number, press Stop/Reset → enter the correct number.

•If you make a mistake, press 4 (–), or press Function → Delete to delete the last number. Or press Function → Clear to delete all numbers you entered → enter the correct number.

•When you have to first dial a digit to get an outside line (“9”, for example), add a pause after that digit by

pressing Redial/Pause.

4-8