3Com EISA 10/100BASE-T Procedures described in this guide are shown in Figure, Procedure Overview

1-2 CHAPTER 1: INTRODUCTION

■Automatic EISA configuration without jumpers

■Three status LEDs

■Single shielded RJ-45 connector for use at either speed (Category 3, 4, or 5 UTP cabling for 10BASE-T Ethernet networks, and Category 5 UTP for 100BASE-TX Fast Ethernet networks)

■Diagnostic software and drivers on the 3C59X EtherDisk® diskette

The Fast EtherLink EISA adapter can be managed remotely with Transcend® PC Link SmartAgent® network management software. Driver agents for this adapter are provided on the 3C59X EtherDisk diskette.

The procedures described in this guide are shown in Figure 1-1.

1

Install the adapter in an EISA slot.

2

Use the EISA configuration utility to configure the adapter.

3

Install network drivers. (NetWare or other)

4

Troubleshoot the adapter.

(optional)

Figure 1-1 Procedure Overview