Extron electronic manual Rear Panels, IPL T PCS4i Rear Panel 220 VAC

Rear Panels

100-120V 10A

1 2 3 4 S/N XXXXXXXXX E0000 0408

00-05-A6-XX-XX-XX 5

50/60 Hz

ALARM

100-120V TOTAL LOAD 10A MAX

LAN

1			2		3	4
Figure 4. IPL T PCS4 Rear Panel (120 VAC)
200-240V 10A	1	2	3	4	S/N XXXXXXXXX E0000 0408

00-05-A6-XX-XX-XX 5

LAN

ALARM

50/60 Hz

200-240V TOTAL LOAD 10A MAX

1 2 3 4

Figure 5. IPL T PCS4i Rear Panel (220 VAC)

APower connector — Connect a power cord from the AC power supply to this male IEC power input receptacle.

NOTE: For the IPL T PCS4, use the supplied 14 AWG IEC power cord (part number 27‑407-01).

BOutput receptacles — Connect power cords from up to four devices to these three-prong female U. S. (IPL T PCS4) or IEC (IPL T PCS4i) power output receptacles.

CAlarm relay — Connect a relay-controllable detection device to this single-pole, single-throw relay connector. (The default condition for this relay is normally open.)

DLAN connector and LEDs — An Ethernet connection can be used on an ongoing basis to monitor and control the PCS4 (and the devices connected to it).

•RJ-45 port — Plug a patch cable into this RJ‑45 female socket, and connect the other end to a network switch, hub, router, or PC.

•Link LED — This green LED lights to indicate a good network connection.

•Activity LED — This yellow LED blinks to indicate network activity.

LAN

RJ-45

Port

Link

LED

Activity

LED

EUID # label — Contains the unique User ID number (MAC address) of the unit (for example, 00-05-A6-00-00-01).

IPL T PCS4 • Installation and Rear Panel 5