Foundry Networks FGS648P-POE, FGS624P-POE, FGS624XGP-POE Ground screw Negative terminal screw

Installing the FastIron GS Chassis

Ground screw Negative terminal screw Handle

Positive terminal screw

NOTE: The handle on the front panel of the power supply may block access to the negative and positive terminal screws. You may need to temporarily remove the receptacle for the positive and negative terminals if you can’t access the screws used to hold the wires in the connectors. The figure below shows the screws that secure the receptacle to the power supply.

6.With one hand, hold the handle on the front panel of the power supply. With the other hand, support the underside of the power supply, and insert the power supply into the empty power supply slot. Press until the supply is completely in the slot, so that the connectors on the back of the supply are fully engaged with the pins on the power backplane.

CAUTION: Make sure you insert the power supply right-side up. It is possible to insert the supply upside down, although the supply will not engage with the power backplane when upside down. The power supply is right-side up when the power connector is on the left and the fan vent is on the right.

September 2007 © 2007 Foundry Networks, Inc. 3 - 9