Connecting Network Devices and Checking Connectivity
Viewing the Results of the Cable Analysis
To display the results of the cable analysis, enter a command such as the following at the Privileged EXEC level of the CLI:
FastIron#sh | 1 |
|
| |
Port | Speed Local pair | Pair Length Remote pair | Pair status | |
01 | 1000M Pair A | <50M | Pair B | Terminated |
| Pair B | <50M | Pair A | Terminated |
| Pair C | <50M | Pair D | Terminated |
| Pair D | <50M | Pair C | Terminated |
Syntax: show
Table 4.3 defines the fields shown in the command output.
This Line...
Port
Speed
Local pair
Pair Length
Remote pair
Pair status
Table 4.3: Cable Statistics
Displays...
The port that was tested.
The port’s current line speed.
The local link name.
The cable length when terminated, or the distance to the point of fault when the line is not up.
The remote link name.
The status of the link. This field displays one of the following:
•Terminated: The link is up.
•Shorted: A short is detected in the cable.
•Open: An opening is detected in the cable.
•ImpedMis: The impedance is mismatched.
•Failed: The TDR test failed.
September 2007 | © 2007 Foundry Networks, Inc. | 4 - 9 |