Foundry Networks FGS624XGP, FGS648P-POE, FGS624P Re-assembling the Chassis, POE Daughter Cards

FastIron GS Compact Layer 2 Switch Hardware Installation Guide

Figure 7.9 shows the location of the POE daughter cards on the main board of the FGS648P-POE.

Figure 7.9 Installing a POE Daughter Card in the FGS648P-POE

POE Daughter Cards

4.Re-assemble the device as instructed in the section “Re-assembling the Chassis” .

5.Power ON the chassis and observe the console. The following message will appear:

Info: PoE module detected in slot 1. Initializing....

6.Enable POE and configure POE parameters. See the Foundry FastIron Configuration Guide for information.

Re-assembling the Chassis

This section provides instructions for re-assembling the FGS device after removing, installing, or replacing a 10- GbE module.

1.Replace the device’s cover by gently guiding the cover into place.

2.Once the cover is properly positioned, re-fasten the screws on each side of the cover.

3.If the device is rack-mounted, replace the mounting brackets.

7 - 14 © 2007 Foundry Networks, Inc. September 2007