FastIron GS Compact Layer 2 Switch Hardware Installation Guide
•#2
•#2
Figure 7.2 shows a front view of the DC power supply.
Figure 7.2 DC Power Supply
Removing a DC Power Supply
1.Turn off the DC power source or disconnect it from the power supply.
2.Loosen the three screws used to hold the wires in the connectors, then pull out the wires.
3.If necessary, remove the power supply locking screw located in the center rear of the device (illustrated below).
Locking screw
4.Press the two latches near the edges of the supply inward to unlock the supply.
5.Hold the handle on the front panel of the power supply and pull outward. This will disconnect the power supply from the backplane.
6.Continue to pull the power supply until it is removed from the device.
7.Place the power supply in an
7 - 6 | © 2007 Foundry Networks, Inc. | September 2007 |