Acroprint ES1000 Setting the Password, Change the first two digits, Change the last two digits

Setting the Password

When the password is set, you are asked to enter it. If the password you entered does not coincide with the setting, you cannot change the setting values.

You may select any 4-digit number from 0001 to 9998 as your password. Note: Numbers "0000" and "9999" are not valid as password.

All settings must be reset if you forget the password. Refer to "8. Resetting".

Push the [SETTING START/END] button before you start setting. At that moment,

" " is indicated on a display and you go into setting mode.

Example Set the password "1234".

PASSWORD

FUNCTION SET

PASSWORD

FUNCTION SET

PASSWORD

FUNCTION SET

Date

AM

Colon

1 Push the [FUNCTION] button for 2 seconds.

2 Once a number on the display starts flashing, position the "" mark over the "PASSWORD" mark by pressing the [FUNCTION] button.

A flashing number can be changed.

3 Change the first two digits.

In case of the example, push the [+] or [-] button to set at "12" and then, push the [SET] button. At that moment, flashing of the display will change to the last two digits.

4 Change the last two digits.

Next, push the [+] or [-] button to set at "34" and then, push the [SET] button. At that moment, the display will change from flashing to steady, and the setting is now completed.

5 Push the [SETTING START/END] button to get out of setting mode. Make sure "date" and "time" are indicated on the display and the colon is flashing. Then replace the cover and lock.

53