Ricoh G413 Opening the VRS Menu, First Time Calibration, To open the VRS menu

Page 14

VRS Getting Started Guide

Opening the VRS Menu

You can open the VRS menu to configure exception condition parameters, preview and update image properties, select a profile or operating mode, or to reset the Adrenaline Hardware Accelerator in your PC.

!To open the VRS menu

1 From the Windows taskbar, right-click on the VirtualReScan icon to open the VRS menu.

Figure 10. VRS Menu

2When using VRS the first time, begin by selecting the Configure command. For more information, see the section Defining Exception Conditions on page 14. For information on other menu options, see the next section, VRS Menu Commands.

First Time Calibration

NOTE: This procedure can be repeated if the preview of the scanned original degrades.

Start Program from Icon on desktop, Double Click VCDemo32.EXE, Maximize

1.Select Source, Scanner from pull-down menus

10	Kofax Image Products

Image 14

Contents Ricoh Copyright Contents VRS Getting Started Guide Introduction Product OverviewScanner VRS Product PackageSystem Requirements To install the VRS software InstallationInstall the Software Setup Complete Dialog Box Compatibility with Current Accelerators and Engines Install the Adrenaline Hardware AcceleratorPrecautions Configure the Accelerator Windows Connect PC to ScannerConfigure the Accelerator Windows NT Kofax Configuration Manager KCM Dialog BoxAttach Your Scanner To connect the scanner to your PCStarting VirtualReScan To start VRSTo open the VRS menu Opening the VRS MenuFirst Time Calibration Select Source, Properties VRS Getting Started Guide Preview ConfigureReset ProfileDefining Exception Conditions CauseContrast Out of Range Threshold Selecting the ThresholdBrightness Out of Range Threshold Missing Corner ThresholdErrors Tab Selecting an ActionError Description Action OptionsTo define exception condition parameters Action Type DescriptionIgnore manual mode only Rescan manual mode onlyVRS manual mode only Auto Resolve check boxStop Every Selecting a ModeStop on Errors Stop on FirstUpdating Image Properties VRS Viewer with the VRS Interactive Properties Dialog BoxUsing mouse buttons to adjust the view Using the VRS ViewerUsing the Zoom Menu to adjust the view Using the VRS Interactive Properties Dialog Box VRS Interactive Properties Dialog Box TabsVRS Interactive Properties Dialog Box Buttons Brightness and Contrast Visual Markers Using the Clarity TabBrightness and Contrast Black LinesDotted Red Lines To change the Clarity settingsBlue Rectangle GammaUsing the Noise Tab To change the Noise settingsVRS Getting Started Guide Using the Skew Tab Skew TabTo change the Skew tab settings Using the Profiles Tab To set up a profileTo change the active profile To remove a profile from the Available Profiles listImage Crop Using the Options TabAutomatic Deskew VRS Refresh Intelligent Contrast Adjustment / Brightness AdjustmentAccelerated Scanning To change the selections on the Options tabUsing the Analysis Tab Analysis TabUsing the About Tab About TabPreviewing Images To preview an imageResetting VRS To reset the VRS configurationTechnical Support Headquarters European HeadquartersPage Index Kofax Image Products VRS Getting Started Guide