Ricoh G413 operating instructions Copyright

Page 2

Copyright

Copyright © 2000 Kofax Image Products. All Rights Reserved. Printed in the USA. Copyright © 2000 Ricoh Corporation. All Rights Reserved.

The information contained in this document is the property of Kofax Image Products. Neither receipt nor possession hereof confers or transfers any right to reproduce or disclose any part of the contents hereof, without the prior written consent of Kofax Image Products. No patent liability is assumed, however, with respect to the use of the information contained herein.

Trademarks

Kofax, ImageControls, and Adrenaline are registered trademarks and VirtualReScan is a trademark of Kofax Image Products.

All other product names and logos mentioned herein are the property of their respective companies.

Disclaimer

The instructions and descriptions contained in this document were accurate at the time of printing. However, succeeding products and documents are subject to change without notice. Therefore, Kofax Image Products assumes no liability for damages incurred directly or indirectly from errors, omissions, or discrepancies between the product and this document.

An attempt has been made to state all allowable values where applicable throughout this document. Any values or parameters used beyond those stated may have unpredictable results.

Image 2
Contents Ricoh Copyright Contents VRS Getting Started Guide Introduction Product OverviewScanner VRS Product PackageSystem Requirements To install the VRS software InstallationInstall the Software Setup Complete Dialog Box Compatibility with Current Accelerators and Engines Install the Adrenaline Hardware AcceleratorPrecautions Configure the Accelerator Windows Connect PC to ScannerConfigure the Accelerator Windows NT Kofax Configuration Manager KCM Dialog BoxAttach Your Scanner To connect the scanner to your PCStarting VirtualReScan To start VRSTo open the VRS menu Opening the VRS MenuFirst Time Calibration Select Source, Properties VRS Getting Started Guide Preview ConfigureReset ProfileDefining Exception Conditions CauseContrast Out of Range Threshold Selecting the ThresholdBrightness Out of Range Threshold Missing Corner ThresholdErrors Tab Selecting an ActionError Description Action OptionsTo define exception condition parameters Action Type DescriptionIgnore manual mode only Rescan manual mode onlyVRS manual mode only Auto Resolve check boxStop Every Selecting a ModeStop on Errors Stop on FirstUpdating Image Properties VRS Viewer with the VRS Interactive Properties Dialog BoxUsing mouse buttons to adjust the view Using the VRS ViewerUsing the Zoom Menu to adjust the view Using the VRS Interactive Properties Dialog Box VRS Interactive Properties Dialog Box TabsVRS Interactive Properties Dialog Box Buttons Brightness and Contrast Visual Markers Using the Clarity TabBrightness and Contrast Black LinesDotted Red Lines To change the Clarity settingsBlue Rectangle GammaUsing the Noise Tab To change the Noise settingsVRS Getting Started Guide Using the Skew Tab Skew TabTo change the Skew tab settings Using the Profiles Tab To set up a profileTo change the active profile To remove a profile from the Available Profiles listImage Crop Using the Options TabAutomatic Deskew VRS Refresh Intelligent Contrast Adjustment / Brightness AdjustmentAccelerated Scanning To change the selections on the Options tabUsing the Analysis Tab Analysis TabUsing the About Tab About TabPreviewing Images To preview an imageResetting VRS To reset the VRS configurationTechnical Support Headquarters European HeadquartersPage Index Kofax Image Products VRS Getting Started Guide