Ricoh G413 Selecting a Mode, Stop Every, Stop on Errors, Stop on First, Stop Never

Page 24

VRS Getting Started Guide

Selecting a Mode

The Mode menu options control the conditions under which the VRS user interface opens for image inspection and interactive updates.

Figure 15. Mode Menu

By selecting the Mode command from the VRS menu, you can request that the VRS user interface display under the following conditions:

Stop Every Page

VRS dialogs open after each document scans; or with duplex scanning, after each document side scans.

Stop on Errors

VRS dialogs open only when exception conditions occur.

Stop on First Page

VRS dialogs open when you scan the first page of a batch and when exception conditions occur.

Stop Never

VRS dialogs remain out of view, even if exception conditions occur. In this case, any exceptions are passed to the scanning application (unless they are defined as Ignore).

After installation, the mode is set to Stop on Errors, which opens the VRS Viewer and the VRS Interactive Properties dialog box when an exception image is detected during the scanning process. Once you select a mode, it stays in effect until you change it again.

!To change the mode

1 From the Windows taskbar, right-click on the VRS icon to open the VRS menu.

2 From the VRS menu, select Mode.

3 From the Mode submenu, select an operating mode.

20	Kofax Image Products

Image 24

Contents Ricoh Copyright Contents VRS Getting Started Guide Introduction Product OverviewVRS Product Package System RequirementsScanner Installation Install the SoftwareTo install the VRS software Setup Complete Dialog Box Install the Adrenaline Hardware Accelerator PrecautionsCompatibility with Current Accelerators and Engines Configure the Accelerator Windows Connect PC to ScannerConfigure the Accelerator Windows NT Kofax Configuration Manager KCM Dialog BoxAttach Your Scanner To connect the scanner to your PCStarting VirtualReScan To start VRSOpening the VRS Menu First Time CalibrationTo open the VRS menu Select Source, Properties VRS Getting Started Guide Configure ResetPreview ProfileDefining Exception Conditions CauseSelecting the Threshold Brightness Out of Range ThresholdContrast Out of Range Threshold Missing Corner ThresholdErrors Tab Selecting an ActionError Description Action OptionsTo define exception condition parameters Action Type DescriptionRescan manual mode only VRS manual mode onlyIgnore manual mode only Auto Resolve check boxSelecting a Mode Stop on ErrorsStop Every Stop on FirstUpdating Image Properties VRS Viewer with the VRS Interactive Properties Dialog BoxUsing the VRS Viewer Using the Zoom Menu to adjust the viewUsing mouse buttons to adjust the view Using the VRS Interactive Properties Dialog Box VRS Interactive Properties Dialog Box TabsVRS Interactive Properties Dialog Box Buttons Using the Clarity Tab Brightness and ContrastBrightness and Contrast Visual Markers Black LinesTo change the Clarity settings Blue RectangleDotted Red Lines GammaUsing the Noise Tab To change the Noise settingsVRS Getting Started Guide Using the Skew Tab Skew TabTo change the Skew tab settings Using the Profiles Tab To set up a profileTo change the active profile To remove a profile from the Available Profiles listUsing the Options Tab Automatic DeskewImage Crop Intelligent Contrast Adjustment / Brightness Adjustment Accelerated ScanningVRS Refresh To change the selections on the Options tabUsing the Analysis Tab Analysis TabUsing the About Tab About TabPreviewing Images To preview an imageResetting VRS To reset the VRS configurationTechnical Support Headquarters European HeadquartersPage Index Kofax Image Products VRS Getting Started Guide