Ricoh G413 operating instructions Installation, Install the Software, To install the VRS software

Page 7

VRS Getting Started Guide

Installation

This section explains how to install the hardware and software required to run VRS. The installation process consists of three basic steps:

1Install the VRS software on your PC.

2Install the Adrenaline Hardware Accelerator in your PC.

3Attach the scanner to your PC.

Step 1. Install the Software

This section explains how to install the VirtualReScan software. The default installation folder is C:\ProgramFiles\Kofax\Imgctls, although you can install to another folder. To install VRS under Windows NT, you must have administrator rights.

If an earlier version of Kofax ImageControls® exists on your computer, you can upgrade it by completing the installation procedure in this section.

!To install the VRS software

1 Verify that the VRS installation CD is inserted in the appropriate CD-ROM drive.

2 Select StartRun and do one of the following to select the path for the setup file on the VRS installation CD. Select the path as D:\Setup.Exe, where D: is the CD-ROM drive:

a Use the Browse button to select the path. b In the text box, type in the path.

3 Click OK.

Figure 1. VRS Installation Program Path

The VirtualReScan Setup dialog box opens, as shown in Figure 2.

Figure 2. VirtualReScan Setup Dialog Box

Kofax Image Products

3

Image 7

Contents Ricoh Copyright Contents VRS Getting Started Guide Product Overview IntroductionSystem Requirements VRS Product PackageScanner Install the Software InstallationTo install the VRS software Setup Complete Dialog Box Precautions Install the Adrenaline Hardware AcceleratorCompatibility with Current Accelerators and Engines Connect PC to Scanner Configure the Accelerator WindowsKofax Configuration Manager KCM Dialog Box Configure the Accelerator Windows NTTo connect the scanner to your PC Attach Your ScannerTo start VRS Starting VirtualReScanFirst Time Calibration Opening the VRS MenuTo open the VRS menu Select Source, Properties VRS Getting Started Guide Profile ConfigureReset PreviewCause Defining Exception ConditionsMissing Corner Threshold Selecting the ThresholdBrightness Out of Range Threshold Contrast Out of Range ThresholdSelecting an Action Errors TabAction Options Error DescriptionAction Type Description To define exception condition parametersAuto Resolve check box Rescan manual mode onlyVRS manual mode only Ignore manual mode onlyStop on First Selecting a ModeStop on Errors Stop EveryVRS Viewer with the VRS Interactive Properties Dialog Box Updating Image PropertiesUsing the Zoom Menu to adjust the view Using the VRS ViewerUsing mouse buttons to adjust the view VRS Interactive Properties Dialog Box Tabs Using the VRS Interactive Properties Dialog BoxVRS Interactive Properties Dialog Box Buttons Black Lines Using the Clarity TabBrightness and Contrast Brightness and Contrast Visual MarkersGamma To change the Clarity settingsBlue Rectangle Dotted Red LinesTo change the Noise settings Using the Noise TabVRS Getting Started Guide Skew Tab Using the Skew TabTo change the Skew tab settings To set up a profile Using the Profiles TabTo remove a profile from the Available Profiles list To change the active profileAutomatic Deskew Using the Options TabImage Crop To change the selections on the Options tab Intelligent Contrast Adjustment / Brightness AdjustmentAccelerated Scanning VRS RefreshAnalysis Tab Using the Analysis TabAbout Tab Using the About TabTo preview an image Previewing ImagesTo reset the VRS configuration Resetting VRSHeadquarters European Headquarters Technical SupportPage Index Kofax Image Products VRS Getting Started Guide