Ricoh G413 operating instructions Select Source, Properties

Page 15

VRS Getting Started Guide

2.Select Ricoh VirtualReScan Source Calibration from pull-down menu, then click on OK

3.Select Source, Properties

4.Verify that the settings are as follows, ADF, 200DPI, Maximum Page Size, Duplex, click on

OK

5.Place the 12”by 12” Calibration Sheet in ADF.

The Document Guides should be at maximum width.

Click on the Scan Page Tool from the

Toolbar to scan and calibrate first image.

Kofax Image Products

11

Image 15
Contents Ricoh Copyright Contents VRS Getting Started Guide Product Overview IntroductionVRS Product Package System RequirementsScanner Installation Install the SoftwareTo install the VRS software Setup Complete Dialog Box Install the Adrenaline Hardware Accelerator PrecautionsCompatibility with Current Accelerators and Engines Connect PC to Scanner Configure the Accelerator WindowsKofax Configuration Manager KCM Dialog Box Configure the Accelerator Windows NTTo connect the scanner to your PC Attach Your ScannerTo start VRS Starting VirtualReScanOpening the VRS Menu First Time CalibrationTo open the VRS menu Select Source, Properties VRS Getting Started Guide Profile ConfigureReset PreviewCause Defining Exception ConditionsMissing Corner Threshold Selecting the ThresholdBrightness Out of Range Threshold Contrast Out of Range ThresholdSelecting an Action Errors TabAction Options Error DescriptionAction Type Description To define exception condition parametersAuto Resolve check box Rescan manual mode onlyVRS manual mode only Ignore manual mode onlyStop on First Selecting a ModeStop on Errors Stop EveryVRS Viewer with the VRS Interactive Properties Dialog Box Updating Image PropertiesUsing the VRS Viewer Using the Zoom Menu to adjust the viewUsing mouse buttons to adjust the view VRS Interactive Properties Dialog Box Tabs Using the VRS Interactive Properties Dialog BoxVRS Interactive Properties Dialog Box Buttons Black Lines Using the Clarity TabBrightness and Contrast Brightness and Contrast Visual MarkersGamma To change the Clarity settingsBlue Rectangle Dotted Red LinesTo change the Noise settings Using the Noise TabVRS Getting Started Guide Skew Tab Using the Skew TabTo change the Skew tab settings To set up a profile Using the Profiles TabTo remove a profile from the Available Profiles list To change the active profileUsing the Options Tab Automatic DeskewImage Crop To change the selections on the Options tab Intelligent Contrast Adjustment / Brightness AdjustmentAccelerated Scanning VRS RefreshAnalysis Tab Using the Analysis TabAbout Tab Using the About TabTo preview an image Previewing ImagesTo reset the VRS configuration Resetting VRSHeadquarters European Headquarters Technical SupportPage Index Kofax Image Products VRS Getting Started Guide