Ricoh G413 operating instructions Preview, Profile, Mode, Configure, Reset

Page 17

VRS Getting Started Guide

10.Engine Load Window will display and disappear when successfully loaded.

VRS Menu Commands

The VRS menu consists of the following commands:

Preview

Use this command to open a sample image, so that you can test image property settings. For more information, see the section Previewing Images on page 37.

Profile

Use this command to select a profile, which consists of user-defined settings for image processing. For more information about profiles, see the section Using the Profiles Tab on page 31.

Mode

Use this command to select an operating mode, which determines the conditions under which the VRS user interface opens during a scanning session. For more information, see the section Selecting a Mode on page 20.

Configure

Use this command to open the VRS Administration Utility dialog box, which is used to define exception condition parameters. For more information, see the section Defining Exception Conditions on page 14.

Reset

Use this command if you are instructed by authorized technical support personnel to reset the configuration for the Adrenaline Hardware Accelerator. For more information, see the section Resetting VRS on page 38.

Kofax Image Products

13

Image 17

Contents Ricoh Copyright Contents VRS Getting Started Guide Product Overview IntroductionScanner VRS Product PackageSystem Requirements To install the VRS software InstallationInstall the Software Setup Complete Dialog Box Compatibility with Current Accelerators and Engines Install the Adrenaline Hardware AcceleratorPrecautions Connect PC to Scanner Configure the Accelerator WindowsKofax Configuration Manager KCM Dialog Box Configure the Accelerator Windows NTTo connect the scanner to your PC Attach Your ScannerTo start VRS Starting VirtualReScanTo open the VRS menu Opening the VRS MenuFirst Time Calibration Select Source, Properties VRS Getting Started Guide Reset ConfigurePreview ProfileCause Defining Exception ConditionsBrightness Out of Range Threshold Selecting the ThresholdContrast Out of Range Threshold Missing Corner ThresholdSelecting an Action Errors TabAction Options Error DescriptionAction Type Description To define exception condition parametersVRS manual mode only Rescan manual mode onlyIgnore manual mode only Auto Resolve check boxStop on Errors Selecting a ModeStop Every Stop on FirstVRS Viewer with the VRS Interactive Properties Dialog Box Updating Image PropertiesUsing mouse buttons to adjust the view Using the VRS ViewerUsing the Zoom Menu to adjust the view VRS Interactive Properties Dialog Box Tabs Using the VRS Interactive Properties Dialog BoxVRS Interactive Properties Dialog Box Buttons Brightness and Contrast Using the Clarity TabBrightness and Contrast Visual Markers Black LinesBlue Rectangle To change the Clarity settingsDotted Red Lines GammaTo change the Noise settings Using the Noise TabVRS Getting Started Guide Skew Tab Using the Skew TabTo change the Skew tab settings To set up a profile Using the Profiles TabTo remove a profile from the Available Profiles list To change the active profileImage Crop Using the Options TabAutomatic Deskew Accelerated Scanning Intelligent Contrast Adjustment / Brightness AdjustmentVRS Refresh To change the selections on the Options tabAnalysis Tab Using the Analysis TabAbout Tab Using the About TabTo preview an image Previewing ImagesTo reset the VRS configuration Resetting VRSHeadquarters European Headquarters Technical SupportPage Index Kofax Image Products VRS Getting Started Guide