Ricoh G413 operating instructions Connect PC to Scanner, Configure the Accelerator Windows

Page 10

VRS Getting Started Guide

Connect PC to Scanner

Make sure switch 4 is down.

NOTE: Verify that the Dip Switches at the back of the “Scanner Control Unit” are in the configuration illustrated below.

Configure the Accelerator - Windows 95

After installing the Adrenaline Hardware Accelerator, power on your PC. Windows detects the Adrenaline Hardware Accelerator, and if you have successfully installed the VRS software, it automatically locates the drivers required by the accelerator.

6	Kofax Image Products

Image 10

Contents Ricoh Copyright Contents VRS Getting Started Guide Introduction Product OverviewSystem Requirements VRS Product PackageScanner Install the Software InstallationTo install the VRS software Setup Complete Dialog Box Precautions Install the Adrenaline Hardware AcceleratorCompatibility with Current Accelerators and Engines Configure the Accelerator Windows Connect PC to ScannerConfigure the Accelerator Windows NT Kofax Configuration Manager KCM Dialog BoxAttach Your Scanner To connect the scanner to your PCStarting VirtualReScan To start VRSFirst Time Calibration Opening the VRS MenuTo open the VRS menu Select Source, Properties VRS Getting Started Guide Preview ConfigureReset ProfileDefining Exception Conditions CauseContrast Out of Range Threshold Selecting the ThresholdBrightness Out of Range Threshold Missing Corner ThresholdErrors Tab Selecting an ActionError Description Action OptionsTo define exception condition parameters Action Type DescriptionIgnore manual mode only Rescan manual mode onlyVRS manual mode only Auto Resolve check boxStop Every Selecting a ModeStop on Errors Stop on FirstUpdating Image Properties VRS Viewer with the VRS Interactive Properties Dialog BoxUsing the Zoom Menu to adjust the view Using the VRS ViewerUsing mouse buttons to adjust the view Using the VRS Interactive Properties Dialog Box VRS Interactive Properties Dialog Box TabsVRS Interactive Properties Dialog Box Buttons Brightness and Contrast Visual Markers Using the Clarity TabBrightness and Contrast Black LinesDotted Red Lines To change the Clarity settingsBlue Rectangle GammaUsing the Noise Tab To change the Noise settingsVRS Getting Started Guide Using the Skew Tab Skew TabTo change the Skew tab settings Using the Profiles Tab To set up a profileTo change the active profile To remove a profile from the Available Profiles listAutomatic Deskew Using the Options TabImage Crop VRS Refresh Intelligent Contrast Adjustment / Brightness AdjustmentAccelerated Scanning To change the selections on the Options tabUsing the Analysis Tab Analysis TabUsing the About Tab About TabPreviewing Images To preview an imageResetting VRS To reset the VRS configurationTechnical Support Headquarters European HeadquartersPage Index Kofax Image Products VRS Getting Started Guide