Ricoh G413 operating instructions Using the Noise Tab, To change the Noise settings

Page 31

VRS Getting Started Guide

Using the Noise Tab

The Noise tab gives you a set of filters that enhance image quality and remove excessive speckling. As you adjust the Noise settings, the effects are applied to the image in the VRS Viewer window. You can fine-tune the settings until the image appearance meets your quality standards.

Note: The Noise tab settings are intended for black and white scanning; they have no effect on grayscale scanning.

Figure 20. Noise Tab

!To change the Noise settings

1 From the VRS Interactive Properties dialog, select the Noise tab.

2Under Enhancement Filters, you can select one of the following: a None: Disables all the enhancement filters.

b Descreening: Activates a shade removal filter that is useful for removing halftone patterns.

c Image smoothing: Activates a filter that helps to smooth characters or lines that appear jagged on your image.

d Image cleanup: Activates a filter that smooths out characters, removes background noise, and eliminates some lines.

3Use the Erosion/Dilation Slider to select the amount of thinning/thickening to apply to image elements.

a For image elements that are ballooned or blended together, improvement occurs as you move the slider toward the Thin setting.

b For image elements that are too thin or too light, improvement occurs as you move the slider toward the Thick setting.

Kofax Image Products

27

Image 31

Contents Ricoh Copyright Contents VRS Getting Started Guide Product Overview IntroductionSystem Requirements VRS Product PackageScanner Install the Software InstallationTo install the VRS software Setup Complete Dialog Box Precautions Install the Adrenaline Hardware AcceleratorCompatibility with Current Accelerators and Engines Connect PC to Scanner Configure the Accelerator WindowsKofax Configuration Manager KCM Dialog Box Configure the Accelerator Windows NTTo connect the scanner to your PC Attach Your ScannerTo start VRS Starting VirtualReScanFirst Time Calibration Opening the VRS MenuTo open the VRS menu Select Source, Properties VRS Getting Started Guide Profile ConfigureReset PreviewCause Defining Exception ConditionsMissing Corner Threshold Selecting the ThresholdBrightness Out of Range Threshold Contrast Out of Range ThresholdSelecting an Action Errors TabAction Options Error DescriptionAction Type Description To define exception condition parametersAuto Resolve check box Rescan manual mode onlyVRS manual mode only Ignore manual mode onlyStop on First Selecting a ModeStop on Errors Stop EveryVRS Viewer with the VRS Interactive Properties Dialog Box Updating Image PropertiesUsing the Zoom Menu to adjust the view Using the VRS ViewerUsing mouse buttons to adjust the view VRS Interactive Properties Dialog Box Tabs Using the VRS Interactive Properties Dialog BoxVRS Interactive Properties Dialog Box Buttons Black Lines Using the Clarity TabBrightness and Contrast Brightness and Contrast Visual MarkersGamma To change the Clarity settingsBlue Rectangle Dotted Red LinesTo change the Noise settings Using the Noise TabVRS Getting Started Guide Skew Tab Using the Skew TabTo change the Skew tab settings To set up a profile Using the Profiles TabTo remove a profile from the Available Profiles list To change the active profileAutomatic Deskew Using the Options TabImage Crop To change the selections on the Options tab Intelligent Contrast Adjustment / Brightness AdjustmentAccelerated Scanning VRS RefreshAnalysis Tab Using the Analysis TabAbout Tab Using the About TabTo preview an image Previewing ImagesTo reset the VRS configuration Resetting VRSHeadquarters European Headquarters Technical SupportPage Index Kofax Image Products VRS Getting Started Guide