Projector Warm Up
What can be done?
When in the ON position (and the CRT run in cycle is OFF), the projector can start up with a warm up period. The warm up time can be set up by the customer as well as the frequency of the warm up source. During the start up a warm up menu will be displayed. This menu offers the option to skip the warm up period by pressing the EXIT key and offers the possibility to adjust the horizontal and vertical amplitude of this white image with the cursor keys. During this warm up period, a full white image is shifted on the CRT faceplate to avoid a burn in.
Every 30 seconds a text box will be displayed on another place on the screen with the remaining time to go. When EXIT is pressed during this warm up period, the warm up menu will be redisplayed with the remaining time indication. Press another time EXIT to interrupt the warm up cycle. When the warm up option is OFF, when switching on the projector, it starts immediately with the projection of the selected source.
How to select?
1.Push the cursor key 
or 
to highlight 'Projector Warm up' (menu 1).
2.Press ENTER to select. The projector warm up menu will be displayed (menu 2).
PROJECTOR |
|
IDENTIFICATION |
|
RUN TIME |
|
CHANGE PASSWORD |
|
CHANGE PROJECTOR ADDRESS |
|
CHANGE BAUD RATE |
|
PROJECTOR WARM UP |
|
POWER UP MODE: operating |
|
COMMON ADDRESS: 0 |
|
Select with or |
|
then <ENTER> |
|
<EXIT> to return | menu 1 |
|
Warm Up On/Off
What can be done?
PROJECTOR WARM UP |
|
WARM UP : ON |
|
FREQUENCY : 64 kHz |
|
TIME : 15 min |
|
A FULL WHITE PATTERN |
|
WILL BE GENERATED AT |
|
POWER UP |
|
AFTER THIS PROCEDURE |
|
THE PROJECTOR IS READY |
|
TO PERFORM IN OPTIMUM |
|
CONDITION |
|
with <ENTER> |
|
<EXIT> to return | menu 2 |
|
The warm up option can be toggled between ON and OFF.
When in the ON position, while starting up the projector, the warm up cycle will be executed. When in the OFF position, the projector starts up with inmediate image projection.
How to turn on the Warm up mode?
1.Push the cursor key 
or 
to highlight 'Warm up' (menu 1).
2.Press ENTER to toggle between ON and OFF.
PROJECTOR WARM UP |
|
WARM UP : ON |
|
FREQUENCY : 64 kHz |
|
TIME : 15 min |
|
A FULL WHITE PATTERN |
|
WILL BE GENERATED AT |
|
POWER UP |
|
AFTER THIS PROCEDURE |
|
THE PROJECTOR IS READY |
|
TO PERFORM IN OPTIMUM |
|
CONDITION |
|
with <ENTER> |
|
<EXIT> to return | menu 1 |
|
58