MESSAGES, WARNINGS AND FAILURES
INPUT 01
RGB2
Fh= 15.6 kHz
Fv= 050 Hz
SOURCE 01
RGB2
enter
password
x x x x
TEXT on
SOURCE 01
RGB2
xxxkHz
xxHz
TEXT off
PROJECTOR
ADDRESS :
003
WRONG
PASSWORD
!!!
When selecting a new source, informa- tion about this source will be displayed on the screen. Source number, hori- zontal and vertical frequencies of the displayed source.
Announcement of the selected source.
Message to enter your password. Password contains 4 digits.
These messages will be displayed on the screen when pushing the TEXT key.
Text ON : the 'bar scale indication' will be enabled during the change of an analog control in the 'operational mode'
+all warnings and failures will be dis- played.
Text OFF : the 'bar scale indication' will be disabled during the change of an analog control in the 'operational mode'
+all warnings and failures will not be displayed.
Indication of the projector address
when activating the 'ADDRESS' button on the Remote with a pencil or other small object.
Message when the entered password is wrong.
WARNING :
source not
available
WARNING :
invalid
key entry
WARNING :
end of ad- just range
WARNING :
input
no longer available
WARNING :
invalid
frequency
input
WARNING : permanent BOOST mode in use !!!
WARNING : Option not installed !
The input is a valid input but the source is not connected to the input terminals or the input source is switched off.
When a wrong key is pressed on the Remote.
End of adjustment range.
The input source is no longer available.
The entered frequency or applied frequency of the source is out of the projector's range.
The CRT drive mode is switched to permanent boost.
Option not installed. e.g. Video selected but no decoder installed.
WARNING :
Invalid Code Entry
The entered password is incorrect
79