Runco DTV-1200 owner manual Power Up Mode, Common Address

Power Up Mode

What can be done?

When pressing the power switch, the projector can start up in 'operating mode' or in 'stand-by mode'.

Operating mode: the projector start up and displays image.

Stand-by mode: the projector start up in stand-by and waits until the stand-by button or a digit key is pressed.

How to change the mode?

To change the Power up mode:

1.Push the cursor key or to highlight Power Up (menu 1).

2.Press ENTER to toggle between 'Operating' and 'Standby'.

PROJECTOR SET-UP

IDENTIFICATION
RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
PROJECTOR WARM UP
POWER UP MODE:
	operating
COMMON ADDRESS: 0
Select with	or
then <ENTER>
<EXIT> to return		menu 1

Note: Runco recommends that this be left in ‘Standby’ for long-term reliability.

Common Address

What can be done?

Every projector listens to a common address. This common address can be set to '0' or '1'. When a Remote is programmed with a common address, every projector with that same common address will follow up the com- mands given by that Remote.

Why 2 different common address?

The reason to have the choice to select between common addresses is, to avoid controlling of other IR con- trolled units, e.g. a TV set with standard common address 0.

How to change the common address?

1.Push the cursor key or to highlight Common Address (menu 1).

2.Press ENTER to toggle between '0' and '1'.

PROJECTOR SET-UP
IDENTIFICATION
RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
Select with or
then <ENTER>
<EXIT> to return	menu 1

60