Runco Connections to the V-50HD/V-63HD and DHD Controller, DVI-to-HDMI adapters will not work

Installation

Proceed as follows to connect the DHD Controller to the V-50HD/V-63HD, your video sources, external controller(s) – if present – and AC power.

To access the rear-panel connectors, use a Phillips screwdriver to loosen the screws securing the protective cover plates (see Figure 2-3)to the panel, then remove the plates.

When connecting your equipment:

•Turn off all equipment before making any connections.

•Use the correct signal cables for each source.

•For best performance and to minimize cable clutter, use high-quality cables that are only as long as necessary to connect two devices. (Don’t use a 20-foot cable when a 6-foot cable will suffice.)

•Ensure that the cables are securely connected. Tighten the thumbscrews on connectors that have them.

Connect the HDMI Out To Display connector on the DHD Controller to the PRIMARY INPUT connector on the V-50HD/V-63HD. See Figure 3-2.Then, re-attach the input cover plate, routing the cable through the nearest slot on the plate.

Caution	Use an HDMI cable for this connection. A DVI cable with
	DVI-to-HDMI adapters will not work.

3.4

Connections to the V-50HD/V-63HD and DHD Controller

Connecting the DHD Controller to the V-50HD/V-63HD

PRIMARY

INPUT

SECONDARY	SERVICE	PRIMARY
INPUT	PORT	INPUT

					HD1
					Y	Video 1	Video 2
					HD2
Y	Pb	Pr					Video 3
			H	V	Pb	Pr
G	B	R

HDMI Out

To Display

RS-232

HDMI Out

To Display

HDMI 2	HDMI 4	Ethernet	HDMI Out
			Audio Only

Figure 3-2. Connecting the V-50HD/V-63HD to the DHD Controller

Vistage™ Series Flat-Panel Display Installation/Operation Manual 17