Runco V-63HD, V-50HD Using Hdmi CEC Messages, CEC Commands Supported by the DHD Controller

Runco V-63HD, V-50HD operation manual Operation Runco V-50HD, V-63HD Maintenance and Troubleshooting, Troubleshooting Tips, Troubleshooting Chart, Primary Input on Runco V-63HD, V-50HD operation manual Troubleshooting Chart Runco V-50HD, V-63HD External Control, Serial Communications, RS-232 Connection, Port Configuration, Serial Command Syntax Runco V-63HD, V-50HD operation manual Serial Commands, Input Selection Commands Runco V-50HD, V-63HD operation manual Picture Adjust Commands Runco V-63HD, V-50HD operation manual Input Position Commands, Output Shift Commands Runco V-50HD, V-63HD operation manual Screen Commands, Miscellaneous Commands Runco V-63HD, V-50HD Using Discrete IR Codes, Command Parameter min/max Value Stored? Description, Enter key, Exit key Runco V-50HD, V-63HD operation manual With Toggle Bit = Hex Binary Function Start, Command Bits Runco V-63HD RC5 Control Codes for the DHD Controller, RC5 Data, Remote Control With Toggle Description Button Name Bit = Runco V-50HD, V-63HD operation manual ST60MIN Runco V-63HD, V-50HD operation manual Using Hdmi CEC Messages, CEC Commands Supported by the DHD Controller Runco V-50HD, V-63HD operation manual Messages from the Hdmi Audio Out connector Runco V-63HD, V-50HD operation manual External Control Runco operation manual V-50HD/V-63HD Specifications Runco V-63HD, V-50HD operation manual DHD Controller Specifications Runco V-63HD operation manual 50HD Dimensions, 1shows the V-50HD dimensions Runco V-50HD operation manual 63HD Dimensions, 2shows the V-63HD dimensions Runco V-50HD, V-63HD Supported Timings, Supported Signal Timings by Input, Component, Composite 1 Composite 2 Composite Runco V-63HD, V-50HD operation manual Format Resolution Frequency Rate Hz MHz KHz, Rgbs Runco V-50HD, V-63HD operation manual Pal-M Runco V-63HD, V-50HD operation manual Specifications Runco V-50HD, V-63HD operation manual Runco V-63HD, V-50HD operation manual 020-1114-00 Rev. a April
Page 80

External Control

6.3

Using HDMI CEC Messages

The DHD Controller accepts and can respond to CEC command messages from a disc player, satellite receiver or DVR/set-top box via an HDMI connection. Using CEC, the DHD Controller can perform the following actions:

•Turn itself and the display device on and select the correct input when the source component initiates playback of a disc or recorded program.

•Turn the source component on when you switch to its corresponding input on the DHD Controller.

•Turn the source component off when the DHD Controller is turned off (unless the source component is in playback mode).

•Change its OSD language when a similar change is made at the source.

To use CEC, connect your CEC-compatible sources to the HDMI inputs on the V-50HD/V-63HD. Set the CEC option to On (refer to CEC on page 54). Additional steps may be needed to enable CEC at the source. Refer to the documentation for your source device for more information.

CEC Command List ➤ Table 6-3lists the CEC commands supported by the DHD Controller.

Table 6-3. CEC Commands Supported by the DHD Controller

Opcode

Value

Supported? (√ = Yes, – = No)

 

 

Initiator

Follower

 

 

 

 

 

 

Feature Abort

0x00

√

√

 

 

 

 

Standby

0x36

√

√

 

 

 

 

Routing Change

0x80

√

√

 

 

 

 

Routing Information

0x81

√

√

 

 

 

 

Active Source

0x82

√

√

 

 

 

 

Request Active Source

0x85

√

√

 

 

 

 

Device Vendor ID

0x87

√

√

 

 

 

 

Give Device Vendor ID

0x8C

√

√

 

 

 

 

Vendor Command With ID

0xA0

√

√

 

 

 

 

Polling Message

N/A

√

√

 

 

 

 

Text View On

0x0D

√

–

 

 

 

 

Report Physical Address

0x84

√

–

 

 

 

 

Inactive Source

0x9D

√

–

 

 

 

 

CEC Version

0x9E

√

–

 

 

 

 

Set OSD Name

0x47

√

–

 

 

 

 

Menu Status

0x8E

√

–

 

 

 

 

Report Power Status

0x90

√

–

 

 

 

 

Set Menu Language

0x32

–

√

 

 

 

 

68

Vistage™ Series Flat-Panel Display Installation/Operation Manual

Page 79 Page 81
Image 80
Page 79 Page 81
Contents Vistage Series Page RuncoCare Standard Two Year Limited Warranty RuncoCare Standard FeaturesRuncoCare Claim Procedure Extended Service Options Copyright and Trademarks Important Safety Instructions Product Disposal Table of Contents Maintenance and Troubleshooting SpecificationsOperation External ControlList of Figures List of Figures Introduction About This ManualUsing This Manual Certain featuresSignificance. They also provide supplemental information Degrade performance or cause a malfunctionDescription, Features and Benefits Optional Accessories Indicators Controls and FunctionsVistage Series at a Glance Front-Panel ControlsRemote Control Sensor DHD Controller Front Panel Primary InputMessages from the Hdmi Audio Out connector DHD Controller Rear PanelV-50HD/V-63HD Remote Control Unit DHD Controller/V-50HD/V-63HD Remote ControlLight For more information about aspect ratios, refer to TableCinema Controls and Functions Installation specialist InstallationRemote Control Quick Setup Installation OverviewStep Procedure For Details, Refer OperationInstallation Considerations Synchronization IssuesPossible Audio Latency for Various Input Timings Mounting the V-50HD/V-63HD on a Wall or Table StandAmbient Light Other ConsiderationsRack-Mounting the DHD ControllerConnecting the DHD Controller to the V-50HD/V-63HD Connections to the V-50HD/V-63HD and DHD ControllerUse an Hdmi cable for this connection. a DVI cable with DVI-to-HDMI adapters will not workConnecting Source Components to the DHDComponent Video Source Connections Rgbhv Source Connections Composite Video Source Connections Connecting an Audio Processor or SecondaryDisplay Device to the DHD Controller OptionalEthernet Network RS-232 ControllerConnection Turning on the Power Connecting to AC PowerSetting the Computer Display Properties OperationOperation Using the On-Screen Menus Input PositionService Aspect Ratio Main MenuInput Source Aspect Ratio Settings Remote Aspect Ratio Control Description Key 169Select 169 to view 169 DVDs Hdtv programs in theirRemote Aspect Ratio Control Description Key NativeScreen PictureScreen PictureTypical Gray Bar Pattern for Adjusting Contrast Gray Yellow Cyan Green Magenta Red Blue Gray Yellow Cyan Green Magenta Red Blue Input Position ResolutionInput Position Overscan Modes Memory Presets Memory PresetsAdjust the Phase after adjusting Tracking see below Sleep Timer Sleep TimerSignal InformationInformation SystemCalibration You must enter a passcode to access the Calibration menuCalibration ISF Settings Color Temperature Presets and Associated Color Points High as is necessary to produce the desired brightness Copy/Paste Copied settings are not retained after a power cycleMemory Preset Keystone and Pincushion Distortion Left Middle y setting also controls the Right Middle Image Alignment ControlsTest Patterns and Their Suggested Usage You must enter a passcode to access the Service menuService Grey Bars Input Names Operation If a Display Error Firmware Upgrade functions Operation Onoff Operation 38 and ISF Day/Night Memory Presets Regardless of the Logo LED settingRegardless of the Standby LED setting Operation Maintenance and Troubleshooting Troubleshooting TipsTroubleshooting Chart Symptom Possible Causes SolutionTroubleshooting Chart Port Configuration Serial Command SyntaxExternal Control Serial CommunicationsSerial Commands Input Selection CommandsPicture Adjust Commands Input Position Commands Output Shift CommandsScreen Commands Miscellaneous CommandsUsing Discrete IR Codes Command Parameter min/max Value Stored? DescriptionEnter key Exit keyCommand Bits With Toggle Bit = Hex Binary Function StartRC5 Data Remote Control With Toggle Description Button Name Bit =RC5 Control Codes for the DHD Controller ST60MIN Opcode Value Supported? √ = Yes, = No Initiator Follower Using Hdmi CEC MessagesCEC Commands Supported by the DHD Controller Messages from the Hdmi Audio Out connector External Control V-50HD/V-63HD Specifications SpecificationsV-50HD/V-63HD Specifications DHD Controller Specifications DHD Controller Specifications50HD Dimensions 1shows the V-50HD dimensions63HD Dimensions 2shows the V-63HD dimensionsSupported Signal Timings by Input Supported TimingsComponent Composite 1 Composite 2 CompositeFormat Resolution Frequency Rate Hz MHz KHz RgbsPAL-M Specifications Page 020-1114-00 Rev. a April
Top Page Image Contents