Xerox ls 32270 instruction manual Testing, PCL driver

Page 12

Installation

Xerox LS 3270

2.3. Testing

PCL driver:

The default configuration of the interface will suffice for most application programs and uses. You should only change the configuration shown in the test printout if you have special requirements.

If you should wish to change the configuration, the options may be set from the line as described in the Programmer's Guide; document no. D62077 (see "Related Manuals").

FSL Driver

With the FSL driver you have selected an unprogrammed printer driver. You have to program the internal setup of the box to suit your printing requirements. See Programmer's Guide; document no. D62077 for further details.

1.Power the unit ON.

2.Turn the rotary switch to the “T” position and back to the original position. This will generate a settings printout.

3.When the switch has been turned back to its original position, the CU indicator will start flashing for approximately 30 seconds.

4Turn the rotary switch to the “T” position once again while the CU indicator is flashing. The unit will now enter Online HEX dump mode. The dump mode is terminated by turning the switch away from and back into the “T” position.

NOTE:

The CU indicator will be blinking rapidly while the rotary switch is in the “T” position. This is an indication that the “T” position is not a valid permanent position.

5.Compare the settings printout (FSL or PCL printout) with the printout illustrated in C hapter 8, Test Printouts.

- 12 -

Image 12
Contents Rank Xerox Electronic Documentation Preface Related ManualsSeptember Table of Contents What is the Xerox LS 3270? PCL Driver DefaultIntroduction to the Xerox LS PCL or FSL output driverXerox LS 3270 Features Changing the DriverInstallation Requirements Supported Control UnitsPaper Size Default US/EU Operating EnvironmentInstallation of the Xerox LS Knowing the Front PanelInstallation Pre-Installation InformationPrinter Dependency Installation Procedure Below follows the procedure for installing the Xerox LSAutomatic Power Supply Control Xerox LS 3270 and its side panelTesting PCL driverTimeout Indicators of the Xerox LS Operation of the Xerox LSCU Contact with Control Unit PAR Parallel inputSpecifying Timeout 3NVRAM = Non-volatile RAM Programming theXerox LS Setup functions supported in PCL mode ESC Features Where % is the defined ESC characterWhere % is the defined ESC character Send Logo User Settings Functions X-Functions Test functions T-FunctionsEngineering Functions FunctionsSetup Functions supported in FSL mode ESC Features User Settings Functions X-Functions FSL Setup via Xerox LS 3270 Parallel Port ??%%Y100,10,’SHARESTRING’%%X1Limitations when Y249 is active Activating the Y249 Engineering FunctionDeactivating the Y249 Engineering Function Updating firmware Error Messages Recoverable ErrorsThere is no Space Left Dynamic Area Non-Recoverable Hardware Errors Busy Timeout Timeout Coax Test PrintoutsPCL Test Printout Proportional Spaced = Active Gfid =Busy Timeout FSL Test PrintoutAppendix A. Quick Reference Guide to FSL Functions FSL N/SLPI LPI FSL N/SEbcdic Y10 Y12 Y13 Are wrappedY19 Y22Name Syntax Parameters Deviations Y35 EAB Y39Y41 IRQ Y47ESC EEPROM/RAMEeprom Y52 Y53Y54 Y55 Y56Y59 Y60Y71 Y74HEX PCL mode FSL modeAscii HEX N2dataY79 APLName Syntax Parameters Deviations Y91 Y92Y93 Y94Y96 Y98APO Y110Y111 Y112Y113 Y114 Y115Y119 Re. T2 RAMData Appendix B. Selected Xerox Products Coax Supported Printers ExternalIndex Coax