Xerox ls 32270 instruction manual Non-Recoverable Hardware Errors

Page 29

Error Messages

Xerox LS 3270

THE USER ADDRESS STRING IS TOO LONG

TERMINATOR NOT ACCEPTED

ESC Z IS WRONG

Validation value in FLASH PROM is wrong

YOU CANNOT LOCK THE FLASH PROM

BEFORE YOU HAVE PROGRAMMED IT

7.2. Non-Recoverable Hardware Errors

The following recovery attempt can be made:

∙Turn power OFF for 10 seconds and then ON again. If the problem persists, seek technical assistance.

The non-recoverabel error messages consist of this message: HARDWARE MALFUNCTION. Call for service.

followed by one of these diagnostic messages: COAX IF ram error

Wrong data in selftest Wrong word in selftest Nothing received in selftest 8085 ram error

Rom check sum error

Response missing from COAX IF

Invalid test response from COAX IF

- 29 -

Image 29

Contents Rank Xerox Electronic Documentation September PrefaceRelated Manuals Table of Contents PCL Driver Default What is the Xerox LS 3270?Introduction to the Xerox LS PCL or FSL output driverChanging the Driver Xerox LS 3270 FeaturesSupported Control Units Installation RequirementsOperating Environment Paper Size Default US/EUKnowing the Front Panel Installation of the Xerox LSPrinter Dependency InstallationPre-Installation Information Below follows the procedure for installing the Xerox LS Installation ProcedureXerox LS 3270 and its side panel Automatic Power Supply ControlPCL driver TestingTimeout Operation of the Xerox LS Indicators of the Xerox LSCU Contact with Control Unit PAR Parallel inputSpecifying Timeout 3NVRAM = Non-volatile RAM Programming theXerox LS Setup functions supported in PCL mode Where % is the defined ESC character Send Logo ESC FeaturesWhere % is the defined ESC character Test functions T-Functions User Settings Functions X-FunctionsEngineering Functions FunctionsSetup Functions supported in FSL mode ESC Features User Settings Functions X-Functions ??%%Y100,10,’SHARESTRING’%%X1 FSL Setup via Xerox LS 3270 Parallel PortDeactivating the Y249 Engineering Function Limitations when Y249 is activeActivating the Y249 Engineering Function Updating firmware Recoverable Errors Error MessagesThere is no Space Left Dynamic Area Non-Recoverable Hardware Errors PCL Test Printout Busy Timeout Timeout CoaxTest Printouts Active Gfid = Proportional Spaced =FSL Test Printout Busy TimeoutFSL N/S Appendix A. Quick Reference Guide to FSL FunctionsLPI LPI FSL N/SEbcdic Y10 Y12 Are wrapped Y13Y19 Y22Name Syntax Parameters Deviations Y35 Y41 EABY39 Y47 IRQEeprom ESCEEPROM/RAM Y54 Y52Y53 Y56 Y55Y59 Y60HEX Y71Y74 FSL mode PCL modeAscii HEX N2dataAPL Y79Name Syntax Parameters Deviations Y92 Y91Y93 Y94Y98 Y96APO Y110Y113 Y111Y112 Y119 Y114Y115 Data Re. T2RAM Coax Supported Printers External Appendix B. Selected Xerox ProductsCoax Index