Xerox ls 32270 instruction manual Paper Size Default US/EU, Operating Environment

Page 7

Introduction

Xerox LS 3270

1.5 Paper Size Default (US/EU)

When you receive the Xerox LS 3270, the box is ready to connect to the system and to the printer. From the factory, the Xerox LS 3270 interface is set up for either US (Letter) or European (A4) paper size (depending on what you specified when ordering the Xerox LS 3270). If, however, you should need to change the default, you may do this by using the FSL function Y8 (see Appendix A for details).

1.6. Operating Environment

The Xerox LS 3270 protocol converter can be installed in the following environment:

Works in the complete temperature range specified for the connected printer if not exceeding 45° Centigrade

Relative humidity between 8% to 80%, non-condensing

External power supply: 5V (250 mAmps).

- 7 -

Image 7
Contents Rank Xerox Electronic Documentation Related Manuals PrefaceSeptember Table of Contents PCL or FSL output driver What is the Xerox LS 3270?PCL Driver Default Introduction to the Xerox LSChanging the Driver Xerox LS 3270 FeaturesSupported Control Units Installation RequirementsOperating Environment Paper Size Default US/EUKnowing the Front Panel Installation of the Xerox LSPre-Installation Information InstallationPrinter Dependency Below follows the procedure for installing the Xerox LS Installation ProcedureXerox LS 3270 and its side panel Automatic Power Supply ControlPCL driver TestingTimeout PAR Parallel input Indicators of the Xerox LSOperation of the Xerox LS CU Contact with Control UnitSpecifying Timeout 3NVRAM = Non-volatile RAM Programming theXerox LS Setup functions supported in PCL mode Where % is the defined ESC character ESC FeaturesWhere % is the defined ESC character Send Logo Functions User Settings Functions X-FunctionsTest functions T-Functions Engineering FunctionsSetup Functions supported in FSL mode ESC Features User Settings Functions X-Functions ??%%Y100,10,’SHARESTRING’%%X1 FSL Setup via Xerox LS 3270 Parallel PortActivating the Y249 Engineering Function Limitations when Y249 is activeDeactivating the Y249 Engineering Function Updating firmware Recoverable Errors Error MessagesThere is no Space Left Dynamic Area Non-Recoverable Hardware Errors Test Printouts Busy Timeout Timeout CoaxPCL Test Printout Active Gfid = Proportional Spaced =FSL Test Printout Busy TimeoutLPI FSL N/S Appendix A. Quick Reference Guide to FSL FunctionsFSL N/S LPIEbcdic Y10 Y12 Y22 Y13Are wrapped Y19Name Syntax Parameters Deviations Y35 Y39 EABY41 Y47 IRQEEPROM/RAM ESCEeprom Y53 Y52Y54 Y60 Y55Y56 Y59Y74 Y71HEX N2data PCL modeFSL mode Ascii HEXAPL Y79Name Syntax Parameters Deviations Y94 Y91Y92 Y93Y110 Y96Y98 APOY112 Y111Y113 Y115 Y114Y119 RAM Re. T2Data Coax Supported Printers External Appendix B. Selected Xerox ProductsCoax Index