Xerox ls 32270 instruction manual Specifying Timeout

Page 15

Specifying Timeout

Xerox LS 3270

4. Specifying Timeout

In order to specify the timeout for a specific input port, an FSL (Function Selection via the Line) sequence must be sent to the port in question. To do this a tempo rary Escape (ESC) Character must be defined first. This is done in the following way:

&&??<character>

The sequence "&&??%" will define "%" as the ESC Character.

Timeout is specified in FSL Function 100 . This function has the following syntax ("%" is the ESC Character):

%Y100,<timeout>[,user string]%

Factory default = 20 seconds

Timeout:

0 to 255 indicating number of seconds

User string: Optional - string in HEX to be sent to the printer before transmission of data, when the printer is selected by the share unit.

If function 100 is sent to the coax, a user string number can be defined instead of a HEX string. The user string then has to be defined in function 61.

NOTE:

The Timeout string must be written in ONE line (see example overleaf).

The user string and settings will only be sent if a share condition has occurred.

- 15 -

Image 15
Contents Rank Xerox Electronic Documentation Preface Related ManualsSeptember Table of Contents PCL or FSL output driver What is the Xerox LS 3270?PCL Driver Default Introduction to the Xerox LSChanging the Driver Xerox LS 3270 FeaturesSupported Control Units Installation RequirementsOperating Environment Paper Size Default US/EUKnowing the Front Panel Installation of the Xerox LSInstallation Pre-Installation InformationPrinter Dependency Below follows the procedure for installing the Xerox LS Installation ProcedureXerox LS 3270 and its side panel Automatic Power Supply ControlPCL driver TestingTimeout PAR Parallel input Indicators of the Xerox LSOperation of the Xerox LS CU Contact with Control UnitSpecifying Timeout 3NVRAM = Non-volatile RAM Programming theXerox LS Setup functions supported in PCL mode ESC Features Where % is the defined ESC characterWhere % is the defined ESC character Send Logo Functions User Settings Functions X-FunctionsTest functions T-Functions Engineering FunctionsSetup Functions supported in FSL mode ESC Features User Settings Functions X-Functions ??%%Y100,10,’SHARESTRING’%%X1 FSL Setup via Xerox LS 3270 Parallel PortLimitations when Y249 is active Activating the Y249 Engineering FunctionDeactivating the Y249 Engineering Function Updating firmware Recoverable Errors Error MessagesThere is no Space Left Dynamic Area Non-Recoverable Hardware Errors Busy Timeout Timeout Coax Test PrintoutsPCL Test Printout Active Gfid = Proportional Spaced =FSL Test Printout Busy TimeoutLPI FSL N/S Appendix A. Quick Reference Guide to FSL FunctionsFSL N/S LPIEbcdic Y10 Y12 Y22 Y13Are wrapped Y19Name Syntax Parameters Deviations Y35 EAB Y39Y41 Y47 IRQESC EEPROM/RAMEeprom Y52 Y53Y54 Y60 Y55Y56 Y59Y71 Y74HEX N2data PCL modeFSL mode Ascii HEXAPL Y79Name Syntax Parameters Deviations Y94 Y91Y92 Y93Y110 Y96Y98 APOY111 Y112Y113 Y114 Y115Y119 Re. T2 RAMData Coax Supported Printers External Appendix B. Selected Xerox ProductsCoax Index