SMC Networks SMC8150L2 manual Dot1x timeout re-authperiod, Dot1x timeout tx-period

Authentication Commands 4

Command Mode

Interface Configuration

Example

Console(config)#interface eth 1/2

Console(config-if)#dot1x timeout quiet-period 350

Console(config-if)#

dot1x timeout re-authperiod

This command sets the time period after which a connected client must be re-authenticated.

Syntax

dot1x timeout re-authperiod seconds no dot1x timeout re-authperiod

seconds - The number of seconds. (Range: 1-65535)

Default

3600 seconds

Command Mode

Interface Configuration

Example

Console(config)#interface eth 1/2

Console(config-if)#dot1x timeout re-authperiod 300

Console(config-if)#

dot1x timeout tx-period

This command sets the time that an interface on the switch waits during an authentication session before re-transmitting an EAP packet. Use the no form to reset to the default value.

Syntax

dot1x timeout tx-period seconds no dot1x timeout tx-period

seconds - The number of seconds. (Range: 1-65535)

Default

30 seconds

Command Mode

Interface Configuration

4-85