SMC Networks SMC8150L2 manual Class, No class class-map-name, Policy Map Configuration

4 Command Line Interface

Command Usage

•Use the policy-mapcommand to specify the name of the policy map, and then use the class command to configure policies for traffic that matches criteria defined in a class map.

•A policy map can contain multiple class same interface with the service-policy

statements that can be applied to the command (page 4-199).

• You must create a Class Map (page 4-195)before assigning it to a Policy Map.

Example

This example creates a policy called “rd_policy,” uses the class command to specify the previously defined “rd_class,” uses the set command to classify the service that incoming packets will receive, and then uses the police command to limit the average bandwidth to 100,000 Kbps, the burst rate to 1522 bytes, and configure the response to drop any violating packets.

Console(config)#policy-map rd_policy Console(config-pmap)#class rd_class Console(config-pmap-c)#set ip dscp 3 Console(config-pmap-c)#police 100000 1522 exceed-action drop Console(config-pmap-c)#

class

This command defines a traffic classification upon which a policy can act, and enters Policy Map Class configuration mode. Use the no form to delete a class map and return to Policy Map configuration mode.

Syntax

[no] class class-map-name

class-map-name- Name of the class map. (Range: 1-16 characters)

Default Setting

None

Command Mode

Policy Map Configuration

Command Usage

•Use the policy-mapcommand to specify a policy map and enter Policy Map configuration mode. Then use the class command to enter Policy Map Class configuration mode. And finally, use the set and police commands to specify the match criteria, where the:

-set command classifies the service that an IP packet will receive.

-police command defines the maximum throughput, burst rate, and the action that results from a policy violation.

•You can configure up to 16 rules per Class Map. You can also include multiple classes in a Policy Map.

4-196