SMC Networks SMC8150L2 manual Snmp Commands Function Mode

4 Command Line Interface

SNMP Commands

Controls access to this switch from management stations using the Simple Network Management Protocol (SNMP), as well as the error types sent to trap managers.

SNMP Version 3 also provides security features that cover message integrity, authentication, and encryption; as well as controlling user access to specific areas of the MIB tree. To use SNMPv3, first set an SNMP engine ID (or accept the default), specify read and write access views for the MIB tree, configure SNMP user groups with the required security model (i.e., SNMP v1, v2c or v3) and security level (i.e., authentication and privacy), and then assign SNMP users to these groups, along with their specific authentication and privacy passwords.

Table 4-37 SNMP Commands

Command	Function	Mode	Page
snmp-server	Enables the SNMP agent	GC	4-101
show snmp	Displays the status of SNMP communications	NE, PE	4-101
snmp-server community	Sets up the community access string to permit access to	GC	4-102
	SNMP commands
snmp-server contact	Sets the system contact string	GC	4-103
snmp-server location	Sets the system location string	GC	4-103
snmp-server host	Specifies the recipient of an SNMP notification operation	GC	4-104
snmp-server enable traps	Enables the device to send SNMP traps (i.e., SNMP	GC	4-106
	notifications)
snmp-server engine-id	Sets the SNMP engine ID	GC	4-107
show snmp engine-id	Shows the SNMP engine ID	PE	4-108
snmp-server view	Adds an SNMP view	GC	4-109
show snmp view	Shows the SNMP views	PE	4-110
snmp-server group	Adds an SNMP group, mapping users to views	GC	4-110
show snmp group	Shows the SNMP groups	PE	4-112
snmp-server user	Adds a user to an SNMP group	GC	4-113
show snmp user	Shows the SNMP users	PE	4-115

4-100