SMC Networks SMC8150L2 manual Switch Cluster Commands, Show ip dhcp snooping

Switch Cluster Commands 4

show ip dhcp snooping

This command shows the DHCP snooping configuration settings.

Command Mode

Privileged Exec

Example

Console#show ip dhcp snooping

Global DHCP Snooping status: disable

DHCP Snooping is configured on the following VLANs: 1

Verify Source Mac-Address: enable

Interface	Trusted
----------	----------
Eth 1/1	No
Eth 1/2	No
Eth 1/3	No
Eth 1/4	No
Eth 1/5	Yes

show ip dhcp snooping binding

This command shows the DHCP snooping binding table entries.

Command Mode

Privileged Exec

Example

Console#show ip dhcp snooping binding			VLAN Interface
MacAddress	IpAddress	Lease(sec) Type
11------------------22-33-44-55-66192.168.0.99---------------		----------0Static-------------------	---------
			1 Eth 1/5
Console#

Switch Cluster Commands

Switch Clustering is a method of grouping switches together to enable centralized management through a single unit. A switch cluster has a “Commander” unit that is used to manage all other “Member” switches in the cluster. The management station uses Telnet to communicate directly with the Commander throught its IP address, and the Commander manages Member switches using cluster “internal” IP addresses. There can be up to 16 Member switches in one cluster. Cluster switches are limited to within a single IP subnet.

Table 4-79 Switch Cluster Commands

Command	Function	Mode	Page
cluster	Configures clustering on the switch	GC	4-238
cluster commander	Configures the switch as a cluster Commander	GC	4-239

4-237